[After the battery is replaced or if the hands are
in the wrong position]
USE the following ALL RESET operation to adjust
the position of the hands if:
□ In the Time Mode
The function hand A
does not point to EXIT.
The mode hand B does
not point to 0.
□ In the Diving Mode
The function hand A
does not point to 0.
The mode hand B does not point to DV.
□ In the Chronograph Mode
The chronograph minute hand B does not point
to 0.
The chronograph second hand A does not point
to 0.
The chronograph 1/20 second hand F does not
point to 0.
□ The display is abnormal in any other way.
[Using ALL RESET and Adjusting the position of
the hands.]
1. Unscrew the crown to release it, pull it out two steps.
2. Simultaneously press
ࠗ1 and button ࠗ2 and then
release them. ALL RESET is complete if the
function hand moves slightly.
3. Pressing button
ࠗ2 will allow the mode hand B and
the function hand A to move simultaneously. Set
both of these to the 0 position. Move the two hands
forward rapidly by pressing button
ࠗ2 continuously.
4. Align the second hand F to the 0 position by
pressing button
ࠗ1 . Move it forward rapidly by
pressing button
ࠗ2 continuously.
5. Set the correct time. Refer to page 12 for
instructions on setting the time and date.
6. Push the crown back to its original position, press
down and turn it to screw lock it back to place.
The watch will restart in the Time Mode.
[When the function hand is in the wrong position]
*If, when switching from the Time Mode to the
Chronograph Mode, the function hand does not
point to 0.
In these cases, use the crown and buttons as
follows to adjust the position of the hand.
1. Unscrew the crown in the indicated direction to
release it, pull it out two steps.
2. If the hand is to the left of
the 0 position, press button
ࠗ2 to move it forward
2. to the 0 position. If it is to
the right of the 0 position
press button
ࠗ1 to move it
back to the 0 position.
3. Push the crown back to the original position then
press down and turn it to screw lock it back to place.
[Automatic time adjustment function]
Be sure to complete the hand position adjustment
within four minutes. If so, the hands will spin rapidly
to display correct time when you complete the
adjustment. However, take care not to turn the
crown at this time as it may cause the incorrect time
to be set.
Other functions
[Register-ring]
Use the register-ring to measure elapsed time.
<Use the register-ring>
Before diving, rotate the
register ring to line up the
mark with the minute hand.
Elapsed time is then indicated
by the position of the minute
hand on the register-ring.
Example: In the diagram at left the
minute hand is 10 minutes past the mark,
indicating that 10 minutes has elapsed.
<NOTE>
1. When pulling the crown out two steps, be sure
to do so on dry land when the watch is dry.
2. This adjustment may be performed when the
function hand is within 15 units of the 0 position.
[The Battery]
a) Battery Life
A new battery installed in this watch will last
approximately 2 years.
Standard usage conditions
Number of dives: 30 dives/year
Duration of dives: 1 hour
Chronograph use: 1 hour/day
*Battery life will vary greatly depending on the
function used. Do not use the Diving Mode
when not diving.
b) The original battery
The battery in the watch at the time of purchase
is one used to test the function and performance
of the watch. Please be aware that this watch
battery may last for the 2 years estimated for
normal batteries.
c) Battery replacement
1. All battery replacements should be done by
a Citizen Service Centre. To replace the
battery, please contact the place of purchase
or contact a Citizen Service Centre directly.
2. When replacing the battery, inspection of
water resistance and other parts should be
conducted, and packing materials replaced
as necessary.
3. Battery replacement will result in deletion of
data in the maximum depth memo. Be sure
to record such data in a log book, etc., before
replacing the battery.
4. Leaving a dead battery in the watch may
cause damage to the watch due to leaking
battery fluids.
5. Before using this watch for long periods over-
seas, battery replacement is recommended,
as this service may be available in some
areas.
6. A charge for battery replacement and related
inspection and parts replacement will be levied,
even within the specified warranty period.
