CAUTION
• Be sure to use the watch with the crown pressed
in (normal position). If your watch has a screw type
crown, be sure to tighten the crown completely.
• Do NOT operate the crown with wet fingers or
when the watch is wet. Water may enter the watch
and compromise water resistance.
• If the watch is used in seawater, rinse with fresh
water afterward and wipe with a dry cloth.
• If moisture has entered the watch, or the inside of
the crystal has fogged up and does not become
clear within a day, immediately take the watch to
your dealer or Citizen Service Centre for repair.
Leaving the watch in such a state will allow
corrosion to form inside.
• If seawater enters the watch, place the watch in a
box or plastic bag and immediately take it in for
repair. Otherwise, pressure inside the watch will
increase, and parts (crystal, crown, buttons, etc)
may come off.
CAUTION: Keep your watch clean.
• Leaving dust and dirt deposited between the case
and crown may result in difficulty in pulling the
crown out. Rotate the crown while in its normal
position, from time to time, to loosen dust and dirt
and then brush it all off.
• Dust and dirt tend to be deposited in gaps in the
back of the case or band. Deposited dust and dirt
may cause corrosion and soil your clothing. Clean
the watch occasionally.
Cleaning the Watch.
• Use a soft cloth to wipe off dirt, perspiration and
water from the case and crystal.
• Use a soft, dry cloth to wipe off perspiration and
dirt from the leather band.
• To clean a metal, plastic or rubber watchband,
wash away the dirt with mild soap and water.
Use a soft brush to remove dust and dirt jammed
in the gaps in the metal band. If your watch is not
water-resistant, take it to your dealer.
NOTE: Avoid using solvents (thinner, benzine, etc.)
as they may mar the finish.
CAUTION: Operating environment.
• Use the watch within the operating temperature
range specified in the instruction manual.
Using the watch where the temperatures are
outside the specified range, may result in
deterioration of functions or even stoppage of the
watch.
• Do NOT use the watch in places where it is
exposed to high temperature, such as in a sauna.
Doing so may result in a skin burn.
• Do NOT leave the watch in a place where it is
exposed to high temperature, such as in the glove
compartment or dashboard of a car.
Doing so may result in deterioration of the watch,
such as deformation of the plastic parts.
• Do NOT place the watch close to a magnet.
Timekeeping will become inaccurate if you place
the watch too close to magnetic health equipment
such as a magnetic necklace or a magnetic latch
of a refrigerator door or handbag clasp or the
earphone of a mobile phone. If this has occurred,
move the watch away from the magnet and reset
the time.
• Do NOT place the watch close to household
appliances that generate static electricity.
• Timekeeping may become inaccurate if the watch
is exposed to strong static electricity, such as
emitted from a TV screen.
• Do NOT subject the watch to a strong shock such
as dropping it onto a hard floor.
• Avoid using the watch in an environment where it
may be exposed to chemicals or corrosive gases.
• If solvents, such as thinner or benzine, or
substances containing such solvents come in
contact with the watch, discolouration, melting,
cracking, etc. may result. If the watch comes into
contact with mercury used in thermometers, the
case, band or other parts may become discoloured.
I. SPECIFICATIONS
1. Type Analogue Quartz with
3 Hands
2. Caliber No. A16❈/A27❈
3. Accuracy Within ע15sec/month
(within a normal temp
range of 5°C/41°F to
35°C/95°F)
4. Quartz oscillator frequency 32,768Hz
5. IC: C/MOS-LSI (1pc.)
6. Operational Temp Range -10°C/14°F ~
+60°C/140°F
7. Display Features Time, hour, minute,
second. Calendar: date
(models with date
display)
8. Additional Features Insufficient charge
warning
Quick start
Time setting warning
Overcharge Prevention
9. Contiuous operating time Approx. 16 months
(from full charge to
stop)
Approx. 20 days (from
2 second interval
movement stop)
10. Battery Secondary battery
* Specifications are subject to change without prior
notice.
