3938
<Depth indication>
Indication range: 0 to 50 m (0 to 125 ft) deep (measured every second)
Indication unit: 1 m/5 ft (Decimals of five and above in the first decimal place are
rounded up and anything under five in the first decimal place is rounded down.
Depth less than 1 m/5 ft is indicated as 0 m/0 ft.)
<Manner to read depth indication>
When the watch reaches the depth of 1 m/5 ft or more in diving, it starts
measuring the depth. In diving, the indication by the function hand represents
the depth.
• When the depth is less than 1 m/5 ft, the function hand indicates 0 m/0 ft.
• When the depth exceeds 50 m (125 ft), the function hand stops at the
overzone mark (52-seconds position) to show that the depth is out of the
indication range. As the diver ascends in the water and the depth is less than
50 m (125 ft), the watch again indicates the depth.
<How to cancel the Diving mode>
(1) Press button A for 2 seconds after diving or in the water where it is less than
1 m (5 ft) deep (depth indication: 0 m/0 ft). The Diving mode is canceled and
the watch returns to the Time mode.
(2) When the watch is left for 10 minutes after diving or in the water where it is
less than 1 m (5 ft) deep (depth indication: 0 m/0 ft), the watch automatically
returns to the Time mode with cancellation of the Diving mode. If the watch is
again immersed in the water 1 m (5 ft) or more deep within 10 minutes after
the last dive, the new dive is regarded as a continuation of the last dive and
the watch continues to measure depth.
* Wet detection error indication
If the diving standby mode (water sensor is in action) continues for 1 hour or
more, the function hand points at the overzone mark.
If the watch remains in this status for a long time, refer to “11. MEASURES
AGAINST POSSIBLE PROBLEMS.”
