4746
● The watch does not switch to the Time mode from the Diving mode
(depth indication mode).
When the user climbs to a high place or is on a flight, the watch may
unexpectedly be shifted to the Diving mode because of a sharp change in the
atmospheric pressure (pressure change equivalent to the depth of 1 m/5 ft). If it
occurs, the watch may fail to switch from the Diving mode after the user goes
back to the ground level, because the depth meter function didn’t reset the depth
indication to “0 m (0 ft)”. Besides the aforementioned case, the watch may enter
the Diving mode because the water sensor is activated by sweat or other
moisture.
If the depth indication is less than 4 m (15 ft), press button A for 2 seconds or
more to switch to the Time mode. If the depth indication is more than 4 m (15 ft),
adjust the watch according to “13. ALL RESET/ADJUSTING HAND POSITION”.
● The function hand continues to indicate the overzone mark.
If the water sensor gets dirty or wet, it is activated even when the watch is not
wet and the wet detection error indication (the function hand points to the
overzone mark) appears.
In case the watch falls into this status, carefully clean the water sensor part and
wipe out moisture completely.
* If careful cleaning results in failure in recovering the watch from the above-
mentioned status, it is possible that the pressure sensor is faulty. In that case,
immediately stop using the watch and consult with the store where you
purchased the watch or the nearest Citizen Service Center.
● The watch malfunctions otherwise or shows abnormal reading.
If a strong shock or static electricity is given to the watch, the watch may come
into abnormal running that is out of explanation of this instruction manual.
If the watch falls into such a status, adjust it following the instructions of “13. ALL
RESET/ADJUSTING HAND POSITION”.
