4948
12. SETTING FUNCTION HAND AT “0” POSITION
(1) Set the watch to the Time mode or
Chronograph mode.
Turn the crown to loosen it and pull it
out to the second click stop position.
(2) Press button A or B to set the
function hand to the “0” position.
(3) Press the crown in to the normal
position and turn it until it is tightly
screwed against the case.
“0” position
Within ±15 graduations before/after
the “0” point.
Adjusting position
B
A
* The aforementioned procedure is effectual only when the hand is located
within ±15 graduations before/after the “0” point. When the hand is located
outside the adjustable range, correct the “0” position of the hand referring to
“13. ALL RESET/ADJUSTING HAND POSITION”.
* If the watch has been left without any operation for 3 minutes or longer as the
crown is pulled to the second click stop position, the function hand does not
move regardless of button operation. If the watch falls into such the condition,
press the crown into the normal position and make a fresh start to adjust the
hand position.
* Before unscrewing and pulling out the crown, make sure that the crown is not
wet.
Automatic time correction function
If it takes 4 minutes or less to adjust the position of the function hand in
the Chronograph mode, the watch automatically sets the hour, minute and
second hands for the correct time immediately after the adjustment by the
automatic time correction function. Therefore, if adjustment is finished within
4 minutes, the watch has no need of manual time correction. However, if the
crown is turned during adjustment, the watch will not indicating a correct
time. If adjustment is not complete within 4 minutes, you will need to not only
adjust the “0” position of the second indicator (function hand) in the
Chronograph mode but also to set the correct time.
