631761
4
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
Important notes for siting and installation
Place of installation
Every electronic device generates heat. The rise in temperature, however, lies within a safe range.
Slight colour changes may occur to sensitive furniture surfaces and veneers over the course of time due
to the constant effect of heat. In conjunction with treated furniture surfaces, the unit’s rubber feet can
likewise give rise to changes in colour. Where necessary, place the unit on a suitable pad.
Ventilation
The heat which is generated in this unit is dissipated quite adequately. Never install the receiver in a
cabinet, shelf or rack with inadequate ventilation. Never close off the cooling slots on the unit.
Do not place objects on top of the unit. Maintain a clearance of at least 10 cm above the unit, so that the
heat generated within the unit is conducted away without obstruction.
Humidity, exposure to sunlight, heat
Protect the unit against humidity, drips and splashing.
Do not place the unit close to radiators nor expose it to direct sunlight.
Mains voltage
Operate the receiver only from a 230V / 50 Hz mains voltage.
The unit must not be connected to the mains and switched on until after the connections have been set
up for the antenna and TV set.
Grounding
The parabolic antenna is to be grounded in accordance with regulations. The relevant local and/or
German VDE regulations are to be observed.
Remote control
Place the supplied batteries into the remote control. Ensure correct polarity of the batteries according to
the + and – markings inside the battery compartment!
2. Connections
The following connections are located on the rear panel of the unit:
230V / 50 Hz Connect the mains cable with the mains socket.
AUDIO TV L a. R Audio output, left and right channel for connection to a stereo system.
TV Connect the TV socket to your television set with the Scart cable, which is
included in the scope of delivery.
VCR VCR Scart socket for connection of a video recorder.
SAT IF INPUT Sat IF signal input and output for LNB supply and control signals –
Connect the cable from your satellite system to this socket.
SAT IF OUTPUT IF signal output (Loop-through e.g. to an analogue receiver).
DATA INTERFACE RS 232 interface for serial data transmission for servicing.
0-modem cable (Pin 2 and 3 crossed, Pin 1, 4, 6-9 are not used).
Receiver: PC:
Pin 2 = RXD Pin 2 = RXD
Pin 3 = TXD Pin 3 = TXD
Pin 5 = GND Pin 5 = GND
- 4 -
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für CITYCOM CCR 512-S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von CITYCOM CCR 512-S

CITYCOM CCR 512-S Bedienungsanleitung - Deutsch - 23 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info