Device start-up
Wall Installation
With the help of screws and dowel plugs (not supplied) the mounting can also be
attached to the wall.
To do so, please measure the distance between the indentations on the rear.
Beforehand you should ensure that you will not damage any pipe or electric wiring
hidden in the wall! Then drill holes at this distance.
Charging the Batteries
Inserting the charging cable in the wall holder
After mounting the wall holder:
1. Pass the cable upwards through lower opening of the wall holder.
2. Hold the charger so that the rectangular part of the charger is located right in
front of the slot.
3. Now press the plug straight into the groove and turn it through 90°. The charger
must be connected securely. It must remain in this position and it must not fall
out when inserting or pulling off the vacuum.
Insert the AC adapter in a duly installed 230V/50Hz protective contact socket. The
charging LED lights up. The charging lasts approx. 16 hours. Once the charging is
over, unplug the AC adapter.
Using the Device
Unplug the device and fit on the desired nozzle. To start the vacuuming, press only
the On/Off (I/O) switch. Once you have finished or when the batteries are down,
connect the vacuum to the charger as described in „Charging the Batteries“. Make
sure that the plug is inserted.
Nozzles
Small brush nozzle: For the vacuuming of narrow surfaces and corners.
Large brush nozzle: For the vacuuming of large surfaces.
Crevice nozzle: Perfect for vacuuming the interior of cars.
Floor nozzle: For cleaning carpets or smooth surfaces.
Shoulder straps:
Hook the ends of the shoulder strap with the snap-link in the eyes (4 and 6). Make
sure that the shoulder straps are not wound up. The length of the shoulder strap
can be adjusted with the buckle on the strap by simply pulling one side of the strap.
Thanks to its light weight the hand vacuum can be hung without problems and used
anywhere.
33
GB
