Bedienungsanleitung Clatronic AKS 832 (Seite 28 von 50) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

653897

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

Overview of the Components / Delivery scope

1 Dust container release button

2 Multi-function switch

3 Charging indicator lamp

4 Socket for mains adapter

5 Cable storage compartment with 12 V connection cable

6 Dirt collection container

7 Connector for accessories

8 Crevice nozzle, long

9 Crevice nozzle, short

10 Filter cover

11 Permanent lter

12 Brush attachment

13 Attachment for wet vacuuming

14 Power adapter

Unpacking the device

1. Remove the device from its packaging.

2. Check the delivery scope for completeness.

3. Check the device for any transport damage, in order to

prevent hazards.

NOTE:

In case of any transport damage, contact your dealer

immediately. Do not use a damaged device!

4. Remove the transport safety device from the multi-function

switch.

Instructions for Use

• The device is especially suitable for quickly vacuuming

small amounts of dry dirt or dust.

• It is furthermore suitable for vacuuming a limited amount of

wet dirt or liquids.

• The device is operated via charged battery. Charge the bat-

tery using the power adapter provided. Direct power supply

via mains adapter is not possible.

• If the rechargeable battery is empty, you can continue using

the vacuum cleaner via 12 V mains operation.

Multi-function switch (2)

Use the multi-function switch to select different operating

modes:

O Device off / charging mode

I Device on in battery mode

II Device on in 12 V power supply mode with connection

cable

Nozzle attachments

The different nozzle attachments are easy to attach and to

remove.

Charging the battery

1. Turn off the device (switch position: O).

2. Connect the mains adapter to the socket (4).

3. Connect the mains adapter to a certied wall socket.

Charge the device for 12 hours before rst-time use.

NOTE:

• The indicator lamp lights up red during charging

operation.

• The lamp does not indicate the charging status of

the device.

• It is normal for the device to heat up during charging.

4. Stop any charging operation after a maximum of 12 hours.

CAUTION:

Always disconnect the plug from the wall socket after 12

hours of charging.

NOTE: on battery life:

Observe the following in order to prolong battery life:

• Charge the battery only when it is almost empty.

• Charge the device at an ambient temperature between 0°

and + 40°C.

• If the connection cable of this device has been damaged, it must be

replaced with a special connection cable available from the manu-

facturer or its customer service.

• Do not use any mains adapter other than the one supplied.

• Do not vacuum combustibles or ammable liquids!

• Avoid vacuuming sharp or pointed objects!

• Never vacuum without the lter and lter cover installed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic AKS 832 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info