Bedienungsanleitung Clatronic bs 1255 (Seite 32 von 50) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

319582

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

ENGLISH

Position in Use

• Place your foot on the

unlocking button (1) to

move the handle into

the required position.

• Switch the device on

with the on/off switch

(10).

Instructions for Use

ޥ NOTE:

Now you should vacuum at an even speed. Pressing

hard is not necessary.

CAUTION:

Pay attention to the restricted range due to the length

of the cable!

Avoid damaging the surface being cleaned:

• Do not set the brushes too low!

• Do not allow the machine to remain stationary when

switched on!

Switching off

• Move the handle to a vertical position.

• Switch the device off using the on/off switch.

• Remove the plug connector from the plug socket.

• Use the cable take-up to stow away the cable.

Filter

Your machine has three ﬁ lter systems.

1. Transparent dust collection container

The traditional dust bag system has been replaced by

a transparent dust collection container in which coarse

dirt particles and tiny particles floating in the air are

swirled out of the suction air by the high speed of the

air current.

The quantity of dust can be easily read off at any time

on the container, which is also very easy to empty.

The purchase of dust bags is no longer necessary.

2. Main Filter, Pre-ﬁ lter (in the Dust Container)

WARNING:

Before removing and cleaning the ﬁ lters switch the

device off and remove the plug from the socket.

Once the dust level has reached the MAX mark of the

dust container, please proceed as follows:

1. Press the button (3).

2. Remove the dust container.

3. Empty the contents of the dust container into a

suitable receptacle by pressing button on the dust

container (See illustration a).

ޥ NOTE:

Every third time that the ﬁ lters are emptied, or

in the case of severe soiling, clean the ﬁ lters

by allowing water to ﬂ ow through them against

the direction in which the air blows. The ﬁ lters

should only be re-inserted when they are com-

pletely dry!

4. To do so, release the lid with the main ﬁ lter (b).

ޥ NOTE:

By means of short turns in a clockwise or

anticlockwise direction the following compon-

ents can be removed or separated.

5. Remove the main ﬁ lter (c). This ﬁ lter can also be

cleaned from time to time with the brush.

6. Remove the pre-ﬁ lter (d). These components can

be separated once more (e).

7. When the components have been cleaned

and dried they can be reinstalled. Connect the

components again by short turns in a clockwise or

anticlockwise direction.

3. Motor Protection Filter

Clean the ﬁ lter felt on the bottom of the dust housing

every time you empty the vacuum.

ޥ NOTE:

Every third time that the ﬁ lters are emptied, or in the

case of severe soiling, clean the ﬁ lters by allowing

water to ﬂ ow through them against the direction in

which the air blows. The ﬁ lters should only be re-

inserted when they are completely dry!

Outlet ﬁ lter

We recommend that this ﬁ lter should be cleaned every

ﬁ fth time the vacuum cleaner is emptied.

This ﬁ lter is located behind the ventilation grille (4) of the

front cover. Pull the ﬁ lter out. Clean the ﬁ lter as described

above.

05-BS 1255 32 07.02.2006, 14:35:33 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic bs 1255 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info