Bedienungsanleitung Clatronic BS 1267 (Seite 27 von 42) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

71790

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

ENGLISH

Vacuum power regulator (2)

Low vacuum power: For curtains and delicate fabrics

Medium vacuum power: For long-pile velour carpets and

textile ﬂ ooring

High vacuum power: For sturdy rugs and ﬂ oors

Cable winding device

Pull out the cable up to the maximum length indicated with the

yellow mark. Never pull the cable out up to the red mark as the

cable winding can be damaged. Said damages are not covered

by the warranty.

Winding

Press the carrying handle (3) down with your foot above the

symbol with the plug and guide the cable into the device. Hold

the cable to avoid wrapping.

Nozzle Attachment

Crevice and

jointed nozzle:

For vacuuming upholstery, curtains and

in corners and crevices etc.

„2-in-1“ nozzle: When this is folded toge-

ther it can be used as a groove nozzle.

If you would like to use the brush nozzle,

pull the brush section in the direction of

the arrow until it locks in place.

Upholstery nozzle: For cleaning upholstery, curtains etc.

Floor nozzle: To clean carpets or smooth surfaces.

Smooth

ﬂ oors:

Press down the lever with the brush symbol

with your foot. The brush is now visible.

Carpets: Press the lever In the opposite direction.

The brushes are now retracted.

Releasing the

nozzles:

Pull these off while turning slightly.

Air Slide (1)

Open the air slide on the hose handle in order to regulate the

airﬂ ow or to clear any particles sticking to the nozzle.

Dust bag replacement display (6)

Hold the hose up into air. If the display is red the bag is full.

Please replace it.

Changing the dust bag

• Pull the plug out of the socket.

• Open the lid of the dust bag compartment by the handle (7)

(the cover must click into place).

• Remove the bag by carefully pulling the clamp towards

the front so that the bag becomes more accessible. Then

remove the dust bag by pulling it upwards.

• Insert a new bag. Please ensure that the bag is located

correctly in the guide mechanism. Then reinsert the retainer.

Close the cover so that it snaps into place.

Filter

Your appliance has two ﬁ lters.

Motor protection ﬁ lter (inlet ﬁ lter)

The inlet ﬁ lter is located in the dust bag compartment. The ﬁ lter

is located vertically in the rear section of the dust housing. Pull

the motor protection ﬁ lter upwards and remove it. Clean the en-

gine protection ﬁ lter after 10 dust bag changes. If necessary, the

ﬁ lter can also be washed in warm water without any additives.

Place it back into place only once it is completely dry! Please

push the motor protection ﬁ lter back under the struts and into the

guide mechanisms on the edge so that it is correctly positioned.

Outlet ﬁ lter

The appliance is also equipped with an outlet ﬁ lter. This ﬁ lter is

to be found under the ﬁ lter cover (8).

Press the lever on the upper edge

of the ventilation grille downwards in

order to open it.

Then pull the grille out towards the

front. Remove the ﬁ lter and clean as

described above. Please re-insert the

ﬁ lter correctly and close the ventilation

grille (until it clicks in place).

Cleaning and storage

Cleaning

• Pull the plug out of the socket before cleaning!

• Clean the casing with a dry cloth.

Storage

• Let the iron cool down completely.

• Wind the cable completely.

• Position the device horizontally. Please suspend the hook

(17) of the ﬂ oor nozzle in the parking aid (16) on the back of

the device.

Troubleshooting

• The Device Does Not Work.

Remedy:

Check the connection to the mains.

Check the position of the switch.

• The device does not suck up anything.

Possible Cause:

The suction power is set too low.

Remedy:

Check the position of the control switch.

Possible Cause:

The dust bag is full.

Remedy:

Renew the dust bag.

05-BS 1267 27 16.05.2007, 14:36:18 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic BS 1267 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info