Bedienungsanleitung Clatronic BS 1295 (Seite 32 von 62) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

592078

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

CAUTION:

• Pull out the cable up to the maximum length indicated

with the yellow mark.

• Never pull the cable out up to the red mark as the cable

winding can be damaged.

NOTE:

If the red mark is visible, pull in the cable with the help of the

cable winding button back to the yellow mark.

Electrical connection

• Before connecting the plug to the wall socket, check wheth-

er the mains voltage is correct. Refer to the information on

the rating plate of the device.

• Connect the device to a certied wall socket only.

On/Off button, combined with suction power control (10)

Press:

Press the button to turn the device on or off.

Rotate:

Turn the suction power control clockwise if you want to increase

the suction power.

• Low suction power:

for curtains, sensitive material.

• Moderate suction power:

for deep pile velour carpets and textile oor covering.

• High suction power:

for robust carpets and oors.

Using the Appliance

1. Insert the mains plug into a correctly installed power socket.

2. Turn the device on by the on/off switch by pressing down

the button.

3. Set the “carpet/hard oor” switch, depending on the oor

covering.

4. Adjust the suction power with the suction power control.

5. Vacuum at a steady speed. There is no need to exert pres-

sure.

NOTE:

Pay attention to the range that can be covered with the

cable length!

Air Slide (1)

Open the air slide on the hose handle in order

to regulate the airow or to clear any particles

sticking to the nozzle.

Switching off and Winding up the Mains Lead

1. Turn the vacuum cleaner off by the on/off switch and

remove the plug from the socket.

2. Keep the plug in your hand.

3. Press the cable winding button and guide the cable. Hold

the cable to avoid wrapping.

Maintenance

Dust bag replacement display (12)

Hold the hose up into air. If the display for the vacuum bag

change shows “red”, the dust bag is full. Please change it.

Changing the dust bag

1. Pull the plug out of the socket.

2. Use the opener (15) to open the lid of the dust bag com-

partment.

NOTE:

The lid can be locked in upright position. Do not push the

lid beyond the locking mechanism! Otherwise the mount-

ing could break away.

3. Flip the holder of the dust bag open.

4. Then remove the dust bag by pulling it upwards.

5. Insert a new bag. Please ensure that the bag is located

correctly in the guide mechanism.

6. Press down the fastener with the bag. The bag must be

located completely in the dust bag compartment. Close the

cover so that it snaps into place.

Filter

Your appliance has two lters.

Motor protection lter (inlet lter)

The inlet lter is located in the dust bag compartment. The

lter is located vertically in the rear section of the dust housing.

Remove the lter by pulling upwards.

Cleaning the Filter Element

Clean the engine protection lter after 10 dust bag changes. If

necessary, the lter can also be washed in warm water without

any additives. Place it back into place only once it is completely

dry!

Outlet lter (11)

The appliance is also equipped with an outlet lter.

It is located on the back of the device behind the cover.

1. Press down the button on the cover to open it.

2. Remove the cover.

3. Remove the lter insert and clean it as described above.

4. Once dried completely, reinstall the lter insert.

5. Closing the cover: First position the cover on the bottom.

Then press the button in order to lock the cover on the top.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic BS 1295 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info