Bedienungsanleitung Clatronic db 3107 (Seite 26 von 42) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

323516

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

ENGLISH

Electrical connection

• Make sure that the iron voltage (see name plate) and the

line voltage match.

• Only connect the machine to a properly installed safety

socket, 230 V/50 Hz.

Display

When the device is switched on the words „OFF“ and „STAND-

BY“ appear in the display.

• Press the temperature button to switch on the different

levels:

low temperature for synthetics, silk

medium temperature for wool

high temperature for cotton, linen

MAX highest temperature

ޥ NOTE:

The word „STANDBY“ ﬂ ashes in the display until the

temperature is reached on the soleplate.

• Press the temperature button again to switch off the irony.

The words „OFF“ and „STANDBY“ appear in the display.

AUTO SHUT OFF

AUTO SHUT OFF refers to the ability of the device to switch

itself off.

• Horizontal: If the device is not moved in this position for

approx. 30 seconds it switches itself off. A buzzer is heard

and the word „OFF“ ﬂ ashes. You only need to move the

device and it switches itself back on.

• Vertical: If the device is not moved in this position for ap-

prox. 8 minutes it switches itself off. A buzzer is heard and

the word „OFF“ ﬂ ashes. You only need to move the device

and it switches itself back on.

ޥ NOTE:

If the iron does not „wake up“ immediately after it has switched

itself off, it is possible that the movements are too smooth.

This may be remedied by shaking the iron brieﬂ y.

Ironing without steam (steam jet regulator on „min“)

ޥ NOTE:

This device should only be used for ironing garments and

textiles!

• Place the iron on its stand (9).

• Turn the steam regulator (4) to „min“.

• Sort out the garments according to their ironing temperatu-

res. Start with the lower temperatures.

• Set a level with the temperature button. The word „STAND-

BY“ ﬂ ashes in the display. As soon as it shuts off, the set

temperature is reached. Now you can start to iron.

• Always pull the plug out of the socket after using the iron.

Steam Ironing

• For this a high temperature is needed (cotton, linen).

• The quantity of steam can be regulated using the steam

quantity regulator (4).

Extra steam can be added with the steam jet function „

“ (3).

WARNING: The steam is hot. Danger of scalding!

ANTI-DRIP-SYSTEM

• When ironing at low temperatures, make sure that you

reduce the quantity of steam or iron without steam.

• If the temperature is too low water may leak from the

soleplate.

• The appliance features an „anti-leakage function“ which

deactivates the steam mode if the temperature chosen is

insufﬁ cient for steam operation.

Reﬁ lling the water tank

• Always disconnect the mains plug before reﬁ lling water.

• Set the steam control (4) to „min“ (no steam). Open the lid

of the reﬁ ll inlet (6) and carefully pour in the water. Do not

exceed the MAX line as marked on the water reservoir.

Spray Function („

“)

In order to moisten a section to be ironed press the spray button

(5).

Vertical Steam

This can be used to produce a jet of steam in a vertical direction.

ޥ NOTE:

To avoid excess water leaking from the soleplate do not

operate the steam burst for more than 5 seconds without

interruption.

Replacing the Anti-Calcium Filter

Among the accessories for the device you will ﬁ nd a replace-

ment cartridge for the anti-calcium ﬁ lter. During normal use this

should be replaced approximately every six months.

• On the back of the device you will ﬁ nd

the lock (b) for the water tank. On this

lock there is a retainer (a) with the

anti-calcium ﬁ lter.

• Pull the retainer to separate the

components from one another.

• Replace the cartridges and re-assemble the components.

Cleaning and Storage

• Always remove the mains lead before cleaning!

• Clean the casing with a slightly damp cloth.

• Clean the iron with a slightly humid cloth.

• Always return the steam regulator to the „min“ position after

use and empty the water tank in order to prevent any leaks.

• The device must never be immersed in water!

05-DB 3107 neu 26 15.05.2007, 11:55:13 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic db 3107 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info