483814
31
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
31
CAUTION: INITIAL USE:
Please proceed as follows:
The tank should only be lled up to the maximum mark.
Do not overll!
Close the water tank and place it back in the base.
Connect the base station to a socket with earthing
contact.
Set the desired temperature within the range “● ●” to
● ●”.
The control lamp on the iron lights up.
Wait until the soleplate has heated up. Once the tem-
perature has been reached the control lamp goes off.
Now press the steam jet button (2) for at least 1 minute
or until steam comes out of the soleplate of the iron. This
time is needed for the steam to reach the iron.
NOTE ON STEAM IRONING:
If the temperature control is set to less than “● ●”, the
production of steam is prevented.
Vertical Steam function (Vertical Steam)
This can be used to produce a jet of steam in a vertical direc-
tion. This function can be used to remove creases from hanging
clothes or from curtains.
WARNING:
Never point the steam jet at other people. Danger of burns.
Hang your laundry on a clothes hanger and move the iron to
approximately 2-3 cm away.
How can I replenish the water during operation?
Rell with water before the tank is completely empty.
Place the iron on the rest (6).
Set the temperature control to “MIN”.
Remove the mains plug from the socket.
In order to remove the tank, press the RELEASE button
below the water tank.
Remove the lime lter cartridge.
Fill the tank up to the maximum mark. Do not overll!
Close the water tank.
Reinsert the lime lter cartridge and push the tank back into
the base.
You can now continue ironing.
When you have nished
Now you can start ironing. Always turn the temperature
control to “MIN” after use and remove the mains plug (the
control lamp in the handle goes off).
Remove the mains plug from the socket.
Empty the water tank.
Allow the device to cool down before you put it away.
Cable storage
Wind the mains cable around the cable groove at the foot of
the stand. Secure the mains cable with the supplied cable clip.
Place the mains plug into a loop of the mains cable to secure it.
Anti-scale lter
Your steam iron station is tted with an anti-scale lter. The anti-
scale lter cartridge becomes spent after ltering approximately
18 litres of water, depending on the hardness of your water. It
then loses its effectiveness and must be replaced.
Turn off the appliance.
Disconnect the mains plug from the mains.
Remove the water tank.
Remove the anti-scale lter cartridge.
Fill the tank up to the maximum mark. Do not overll!
Insert a new anti-scale lter cartridge.
Before turning on the appliance, wait a few minutes until
the new lter cartridge is saturated with water.
NOTE:
If you do not have a new anti-scale lter cartridge, you can
still iron with the used cartridge and distilled water.
Cleaning
WARNING:
Always remove the mains lead before cleaning!
Wait until the machine has cooled down completely!
Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might
result in an electric shock or re.
CAUTION:
Do not use a wire brush or any abrasive items.
Do not use any acidic or abrasive detergents.
Clean the casing with a slightly damp cloth.
Clean the sole plate and the rest with a slightly damp cloth.
Any residual water can remain in the water tank, but should
be poured out if it has been in the tank for a prolonged
period.
31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

clatronic-dbs-3461

Suche zurücksetzen

  • Warum brummt meine Bügelstation. Und es kommt kein Dampf
    Eingereicht am 30-8-2022 14:38

    Antworten Frage melden
  • Bei meiner Tefal-Dampfstation stellt sich immer wieder ein starkes brummendes Geräusch ein, das ziemlich laut ist.
    Was tun? Eingereicht am 18-6-2020 14:56

    Antworten Frage melden
  • ich habe die Antikalkpatrone gewechselt und das Bügeleisen brummt. ich habe eine neue Patrone eingewechselt und das Bügeleisen brummt weiter, was mache ich jetzt????? Eingereicht am 12-8-2017 15:30

    Antworten Frage melden
  • Nach Verbrauch der alten Entkalkerpatr. mit neuer P. kein Dampf, kaufte noch mals von einer anderen Fa. gleiche P. origingal für 3461 wider kein Dampf
    Entlüftung nach Anleitung ausgeführt. Knarrt auch manchmal. Eingereicht am 20-1-2017 17:09

    Antworten Frage melden
  • Meine Dampfbügelstation brummt und es kommt kein Dampf mehr. Ich habe eine neue Patrone
    rein, aber daran liegt es nicht. Bitte um Antwort Eingereicht am 29-5-2014 10:04

    Antworten Frage melden
    • Habe zwar ein Dampfbügeleisen einer anderen Marke, jedoch ist die Situation scheinbar die gleiche.
      Nach dem auffüllen des Wassertanks, brummt mein Gerät ziemlich laut und stößt keinen Dampf aus. Nach ausgiebiger Fehlersuche ohne Erfolg habe ich einfach mal das Eisen in die Luft gehalten und es brummen lassen. Und siehe da ... nach circa 2 bis 3min lautstarken Brummens, was ziemlich nervig ist, schoss wieder Dampf heraus und das Brummen verwandelte sich zurück in ein leises Summen.
      Einfach mal ausprobieren. Und schön den Dampfknopf gedrückt halten. Nervt zwar, aber bei mir funktioniert es. Beantwortet 24-6-2014 07:10

      Finden Sie diese Antwort hilfreich? (93) Antwort melden
  • Nach 3/4 Jahr von Nutzung der Bügelstation DBS 3461 ist auf einmal kein Dampf, strom ist da, aber wasser erzogt keinen dampf, was ist kaput? funktioniert die antikalkpatrone nicht, oder ist eine pumpe oder noch was defekt? Eingereicht am 21-9-2013 20:12

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Clatronic DBS 3461 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info