Bedienungsanleitung Clatronic DVG 3686 (Seite 36 von 62) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814204

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

DVG3686_IM 29.08.17

• Keep the appliance and its cord out of reach of children less than

8 years.

CAUTION:

This appliance is not intended for immersion in water during

cleaning. Please refer to the instructions provided in the chapter,

“Cleaning”.

Intended Use

This appliance is used for grilling doner kebab / gyros, meat /

vegetable skewers or poultry.

It is intended for the use in private households and similar

applications. The appliance is only to be used as described

in the user manual. Do not use the appliance for any other

purpose.

Any other use is not intended and can result in damages or

personal injuries.

The manufacturer assumes no liability for damages caused

by improper use.

Unpacking the Appliance

1. Remove the appliance from its packaging.

2. Remove all packaging materials such as lms, ller mate-

rial, cable clips and carton.

3. Check the contents for completeness.

4. In case of incomplete delivery or damage, do not operate

the appliance. Return it to your dealer immediately.

NOTE:

Production residue or dust may have collected on the appli-

ance. We recommend cleaning the appliance according to

chapter “Cleaning”.

Overview of the Components /

Scope of Delivery

1 Reector sheet

2 Gear rim (6 pieces)

3 Kebab skewers (6 pieces)

4 Gearbox with traverse

5 Skewer

6 Rotisserie for kebab skewers

7 Grease drip tray

8 Switch (On / Off)

9 Base

10 Motor shaft with notch

11 Clamp spring for reector sheet

12 Heating element

13 Traverse

14 Locking screw

15 Securing bracket

Assembly

Please take a look at the illustrations on page 3.

Figure A

1. Push the reector sheet between the heating element

and the housing rear panel. The reector sheet’s side

guide rails have to be placed into the lateral recesses of

the housing. Place the reector sheet in front of the clamp

spring. Check that the reector sheet is rmly placed.

2. Put the grease drip tray above the motor shaft at the

center of the appliance.

3. Hold the rotisserie with the tip pointing upwards. Place the

bottom end of the rotisserie into the motor shaft in such a

way that the catch snaps into the notch. You may need to

twist the rotisserie a little.

Figure B

Secure the gearbox with the traverse at the appliance:

1. Loosen the locking screw at the traverse.

2. Slide the traverse with the screw into the securing brack-

et’s recess.

3. Slightly tighten the screw.

4. Place the gearbox onto the tip of the meat skewer. You

may need to twist the gearbox a little.

5. Insert bottom of the traverse into the notch in the center of

the housing rear panel.

6. Hand-tighthen the locking screw.

Notes on Use

Electric Connection

1. Ensure that the switch (8) is set to “ “ position.

2. Before inserting the power plug into the outlet, check

that the mains voltage to be used matches that of the

appliance. You can nd the required information on the

nameplate.

3. Connect the mains plug to a properly installed shockproof

socket only.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Clatronic DVG 3686 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info