Bedienungsanleitung Clatronic fr 3194 (Seite 26 von 42) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

363793

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

ENGLISH

Once the fat has melted and the correct oil level is reached

you can set the desired temperature on the thermostat.

Under no circumstances should you place the fat in the

deep frying basket!

3. In order to reduce the acrylamide content of food containing

starch (potatoes, cereals) the temperature during deep-fat

frying should not exceed 170°C (or possibly 175°C). Fur-

thermore, the frying time should be kept as short as possible

and the food only fried until it turns golden yellow.

4. Please note that the safety switch (6) is operated when the

control element is inserted into the guide mechanism.

5. Choose the right frying temperature and check the condi-

tions of the food to be fried. A rule of thumb is that pre-fried

foods require a higher temperature than raw foods.

6. Do not carry or move the deep fryer if the oil or grease is still

hot.

7. When frying dough-like foods scrape off the excess dough

and put the pieces carefully into the oil.

8. Please ensure that the handle of the deep fat frying basket

has been correctly attached.

• Fold the handle so that it is locked in place in an upward

position.

• The deep fat frying basket must not be more than 2/3

full. Do not overﬁ ll the frying basket (The maximum

ﬁ lling quantity for chips is 200g per litre of oil/fat).

9. Rub dry humid foods with a cloth before frying.

Caution: In the case of foodstuffs which are too moist (e.g.

frozen chips etc.) large amounts of foam may form, which

under certain circumstances may cause the oil to overﬂ ow.

Use

1. Make sure that the appliance is unplugged and switched off

(The control lamps (1,

2) are off.).

2. Take the lid off the deep fryer.

3. Remove the frying basket and ﬁ ll the container with oil or

grease (maximum 2,0 l). The ﬁ lling level must be located

between the minimum and the maximum level.

4. Insert the plug into a 230 V, 50 Hz power socket. The green

POWER control lamp (1) lights up. Set the desired tempe-

rature by turning the temperature control (3) (Min. – approx.

130°C, middle position – approx. 160°C, Max. – approx.

190°C).

5. The red TEMP control lamp (2) lights up. Once the set

temperature has been reached the red control lamp goes

off. Place the frying basket containing the items to be fried

carefully into the hot fat.

6. The red control lamp switches on and off several times

during frying. This is normal and it indicates that the

temperature is controlled by the thermostat and is being

maintained. Once the frying time is over (the frying times are

to be found on the packaging of the food or in the recipe),

please take out the frying basket.

7. Allow the oil to drain off the food being fried by suspending

the deep-frying basket on the edge of the frying fat contai-

ner.

8. In order to switch off the machine, please turn the tempera-

ture regulator to OFF and remove the plug from the socket.

Wind the mains lead up in the form of a spiral in the cable

compartment.

Cleaning

1. Make sure that the plug is pulled out.

2. Wait until the deep fryer is completely cool before cleaning.

Wait in any case for 1 to 2 hours after use before using

again to avoid burns.

3. Pull the control device (5) out by lifting it. In order to change

the oil, pull the frying fat container out and pour the oil out to

the side.

4. Do not immerse the device in water.

5. Clean the deep frying fat container, the lid and the housing

with a damp clothand household detergent if necessary.

6. The deep frying basket can be cleaned in the usual way in

soapy water.

7. Avoid using abrasive materials or sharp objects. These may

damage the deep fryer!

8. Reassemble the deep fryer and push the control device (5)

back into the guide mechanism.

Troubleshooting

Device is not working

Troubleshooting:

Check the mains connection.

Check the position of the thermostat.

Other possible causes:

The device is ﬁ tted with a safety switch (6).

This prevents the heater being switched on accidentally.

Troubleshooting:

Check that the control element is correctly in place.

Overheating Protection

• If you should accidentally switch on your deep fat fryer

when there is no oil or fat in it the overheating protection is

automatically turned on. The appliance is no longer ready

to be used. Unplug the deep fryer.

• Only after the device has been left to cool down completely

should the „RESTART“ button (11) on the rear of the control

element be operated in order to use the deep fat fryer again.

Please use a pointed object for this purpose. The RESTART

button on the front of the control device has no function.

Technical Data

Model: ...............................................................................FR 3194

Power supply: ............................................................230 V, 50 Hz

Power consumption: .......................................................... 1300 W

Protection class: ........................................................................... Ι

Filling quantity: .........................................................max. 2,0 Litre

Net weight: ...........................................................................2,0 kg

05-FR 3194.indd 2605-FR 3194.indd 26 10.09.2007 12:19:08 Uhr10.09.2007 12:19:08 Uhr

Clatronic fr 3194 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info