5. Secure the manual spray gun (8) with the lock (10).
6. Disconnect the device from the water supply by unscrewing the hose on the
water connection (3) of the device.
Cleaning
The device must never be immersed in water to clean it, but should be cleaned with
a soft dry cloth. In the case of stubborn dirt slightly dampen the cloth with water and
then wipe dry.
Storage
Separate the accessories from one another. Allow the accessories and the high-
pressure hose to run empty.
Please note: There is still water in the pump of the high-pressure cleaner. Frost
may damage the pump or internal piping. Therefore the device should always be
stored in rooms away from frost.
Troubleshooting
Device is not working
• Check the mains connection.
• Check the position of the main switch (1).
The motor suddenly stops during operation
• Possible cause: The overheating protection of the pump has been activated.
Switch the machine off and allow it to cool down for approx. 20 min. Then you
can begin work again.
The device does not reach the working pressure
• Bleed the machine: Allow the pump to run without the high-pressure hose until
the water coming out of the high-pressure outlet no longer contains any bub-
bles. Then reconnect the high-pressure hose.
• Clean the filter in the water connection (3).
• Check the water supply amount.
• Check the supply pipes to the pump to see if they are leaking or blocked.
Major fluctuations in pressure
• Clean the high-pressure nozzle: Remove any dirt from the apertures with a
needle.
• Rinse out the dirt by allowing the water to pass through the nozzle in the oppo-
site direction to the jet.
Leaking pump
• It is normal for the pump to leak slightly. Should the leak become larger please
contact our service department.
59
GB
