703404
23
Zoom out
Zoom in
Vorherige Seite
1/52
Nächste Seite
23 EN
Operation
PLEASE NOTE!
Make sure that there are no large, pointy objects on the area to be cleaned.
Pay attention to the dust container’s MAX mark. If the mark is reached during use, em-
pty the dust container. Empty and clean the dust container after each use. The HEPA
lter must also be cleaned regularly to prevent the motor from being overloaded.
Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the “Charging Up the Battery” chapter).
When the device is switched on, the charge status of the battery (4) is indicated
by the two green battery charge status lamps (1). If both lamps are lit up, the
battery is full. If only the red operating lamp (1) is lit up, the battery needs to be
charged up.
1. Select an accessory as required (see the “Device Overview” chapter – Accesso-
ries”) and attach it to the device (see the “Assembly” chapter).
2. Switch the device on. This can be done in one of two ways:
by gently holding the On / Off switch (2) down. The device will switch off when you
let it go.
by rmly pushing the On / Off switch once and then releasing it. If you would like to
switch the device back off, push the On / Off switch again.
3. The device will immediately start to vacuum clean. The operating lamp and the
battery charges status lamps are lit up.
4. Run the device over the area to be cleaned.
5. After vacuuming, switch off the device.
6. To ensure that the device operates optimally, empty and, if necessary, clean the dust
container (7) after each use (see the next chapter).
Cleaning and storage
PLEASE NOTE!
Do not immerse the HEPA lter and the foam lter in water or rinse it under running
water to prevent damage. They are
neither machine-washable, dishwasher-safe
nor suitable for tumble drying.
The lter holder is not suitable for the washing machine, dishwasher or dryer! Only
air dry the lter holder and do not in any case use a hair dryer.
Do not use any corrosive or abrasive cleaners to clean the housing. They could
damage the surface.
The HEPA lter may lose some of its colour over time. This is normal and
does not have any adverse effect on function.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Cleanmaxx PC-P008E - Z01385 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info