646273
21
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
21 EN
3. Pull the catch away from the dust container. The bottom of
the dust container will open and the dirt will fall out.
4. Close the bottom of the dust container again. The fasten-
er must be heard to engage in place.
5. Plug the closed dust container into the motor unit. Press
the dust container handle against the housing until it en-
gages audibly.
Cleaning the Dust Container Cyclone Insert and Motor Filters
The cyclone insert is located in the dust container. The motor lters (HEPA and foam
lter) are seated on the cyclone insert (20).
1. Remove the dust container from the device and empty it (see the “Emptying the Dust
Container” section).
2. Turn the lid of the dust container until the arrow marked
on the edge of the lid is pointed to the
symbol on the
dust container. Then, remove the lid.
3. Turn the HEPA lter (18) a little in an anticlockwise direc-
tion and remove it.
Please note: The HEPA lter is attached to the lter hold-
er and cannot be taken out of the holder!
4. Remove the foam lter (19).
5. Carefully remove the cyclone insert from the dust contain-
er. For this put your hand into the
dust container and push
the
cyclone insert up.
6. Tap out all the parts over a dustbin and brush off the loose
dirt.
7. If necessary, thoroughly rinse the lters using clear, luke-
warm water. CAUTION: Do not use any cleaning agent!
Then shake off any excess water and let the lters dry
completely in the air.
8. Clean the cyclone insert and dust container with a damp cloth.
9. When all parts are dry, reassemble them. CAUTION: Under no circumstances
should you place damp device parts into the dust container!
10. Place the lid onto the dust container so that
the arrow marked on the edge of the lid
is pointed to the
symbol on the dust container. Then
turn the lid as far as it will go
towards the
symbol
.
11. Insert the dust container into the device. Make sure that it audibly locks in place.
18
19
20
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Cleanmaxx Z 08183 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info