773878
6
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
6
4. ASSEMBLY
5. SETTING UP
6. RECOMMENDATIONS OF USE
7. TECHNICAL DATA
8. FAQs
9. GUARANTEE
1.GENERAL INFORMATION
- Climastar Heating System must only be destined for heating.
- A proper design and insulation of the room will ensure that the system provides enough heat for your entire satisfaction.
- The household installation must be under the electro technical low voltage regulation.
- All our devices have an automatic turn off system that works in case of overheating. The device will automatically switch off its work
if it is overheated. When the cause that produced the overheating ceases the device will automatically start functioning again after a
few minutes. If this situation is repeated without the grids being covered or obstructed, please contact the Technical Service.
- The device does not need an earth wire because it is a Class II device (electrically isolated).
- When the device is on its surface remains hot. For security reasons children must be kept away from the radiator.
- Do not cover totally or partially the radiator. Do not place any kind of material, cloths, towels, plastics,…that may limit the air flow in
the upper part of the heater.
- Press the buttons softly to avoid any damage; do not manipulate the device with ball pens or similar to avoid scratches
2.DESCRIPTION / OUTWARD APPEARANCE
LIST OF COMPONENTS
Be sure the following elements are included. If any is missing, please contact your distributor:
1x
2x
4x
4x
3.BEFORE STARTING YOUR DEVICE
- Make sure the supply voltage corresponds with that on the nameplate
- Verify that the system’s or other connection wires are not in contact with the device’s surface.
- If the radiator is located in the kitchen or bathroom/shower, make sure it is placed in such a way that someone in touch with water
cannot activate the controls, in compliance with the regulation in force in each country.
- The heating systems cannot be installed in a location with a high risk of explosion or fire. Example: fuel, oil or gas warehouses, etc…
4.ASSEMBLY
Screw the wheels as shown below:
5.SETTING UP
5.1- STARTING THE DEVICE
First, plug in the power cord to a mains power outlet, and click the switch on the right. Press to turn on the radiator, ECO light turns on.
Wheels
Plug
Switch
Handle
Display
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Climastar Optiplus wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info