1.Place the powerhead/lower tube
assembly and the upper tube
assembly on a clean, flat surfaceso
that both assemblise fit end to end.
The powerhead/lower tube assembly
should be facing up, and the upper
tube assembly should be positioned
with the latch Protector facing up.
Figure
12
Keep the open end of the tubes
clean and free of impurities!
Figure
13
Figure
14
2.Loosen the couplerscrew.
3.Depress the latch and insert the
powerhead/lower tube assembly into
the coupler until it bottoms. Release
the latch. Rock the upper tube
assembly back and forth until you
are sure it snaps in place by the
coupler lock. See Figure 12.
4.When the two tube halves are locked
together, slide the latch protector
into groove of latch, then tighten the
coupler screw. See Figure 13.
Disassembling The Pole sections
1.With the pole pruner on a clean, flat
surface, loosen the coupler screw.
slide the latch protector out of groove
of latch.
2.Depress the latch. This release the
coupler lock. See Figure 14.
3.Pull the upper tube assembly out of
the coupler
8
