Bedienungsanleitung Cobra M51SPB (Seite 14 von 18) (Englisch)

634285

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Fig. 14

10.3 BLADE MOUNTING TORQUE

Center Bolt 40Nm.min, 50Nm.max. To ensure safe operation of your unit. All nuts and bolts must be checked periodically for

correct tightness. After prolonged use, especially in sandy soil conditions, the blade will become worn and lose some of the

original shape. Cutting efficiently will be reduced and the blade should be replaced. Replace with an approved factory

replacement blade only. Possible damage resulting from blade unbalance is not the responsibility of the manufacturer.

When you change the blade, use the original type marked on the blade:

When you change the blade, use the original type marked on the blade (Cobra Part 263001330) (to order the blade, please

contact your local dealer)

WARNING: Do not touch the blade whilst still rotating.

10.4 ENGINE

Refer to the separate engine manual for engine maintenance instructions.

Maintain engine oil as instructed in the separate engine manual packed with your unit.

Read and follow the engine instructions carefully.

Service the air filter as per the separate engine manual. Clean every few hours under extremely dusty conditions. Poor engine

performance and flooding usually indicates that the air filter requires attention. To service the air filter, refer to the separate

engine manual packed with your mower. The spark plug should be cleaned and the gap reset annually. Spark plug replacement

is recommended at the start of each mowing season. Check the engine manual for the correct plug type and gap specifications.

Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to permit proper air

circulation, which is essential to engine performance. Be certain to remove all grass, dirt and combustible debris from the muffler

area.

11. STORAGE INSTRUCTIONS (OFF SEASON)

The following steps should be taken to prepare the lawn mower for storage at the end of the mowing season.

1. Drain the fuel from the engine by running the engine until it stops.

a) Start the engine and let it run until it has used up all remaining petrol and stalls.

b) Remove the spark plug. Use an oilcan to fill approx. 20 ml oil into the combustion chamber. Operate the starter to evenly

distribute the oil in the combustion chamber. Replace the spark plug.

2. Clean and grease the lawnmower carefully as described above under “Lubrication”.

3. Slightly grease the cutter to avoid corrosion.

4. Store the lawnmower in a dry, clean and frost-protected place.

CAUTION! The engine must have completely cooled down before storing the lawnmower.

NOTE: - When storing any type of power equipment in an unventilated or material storage shed,

-Care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all

moving parts.

- Be careful not to bend or kink cables.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cobra M51SPB Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info