Bedienungsanleitung Cobra RM46SPCE (Seite 14 von 19) (Englisch)

634419

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

- 14 -

WARNING: Periodically inspect the blade adapter for cracks, especially if you strike a foreign object.

Replace when necessary.

For best results your blade should be sharp. The blade may be re-sharpened by removing it and either grinding

or filing the cutting edge, keeping it as close to the original bevel as possible. It is extremely important that

each cutting edge receives an equal amount of grinding to prevent an unbalanced blade. An improper blade

balance will result in excessive vibration, causing eventual damage to the engine and mower. Be sure to

carefully balance the blade after sharpening. The blade can be tested for balance by balancing it on a round

shaft screwdriver. Remove metal from the heavy side until it balances evenly.

Before re-assembling the blade and the blade adapter to the mower, lubricate the engine crankshaft and the

inner surface of the blade adapter with a light oil. Install the blade adapter on the crankshaft. Refer to figure 12.

Place the blade with the part number facing away from the adapter. Align the washer over the blade and insert

the hex bolt. Tighten the hex bolt to the torque listed below:

Fig.12

9.3 BLADE MOUNTING TORQUE

Center Bolt 40Nm-50Nm, to insure safe operation of your unit. All nuts and bolts must be checked periodically

for correct tightness.

After prolonged use, especially in sandy soil conditions, the blade will become worn and lose some of the

original shape. Cutting efficiently will be reduced and the blade should be replaced. Replace with an approved

factory replacement blade only. Possible damage resulting from blade unbalance condition is not the

responsibility of the manufacturer.

When you change the blade, you must use the original type marked on the blade (Cobra Part number

263001465. Please contact your local dealer to order a replacement)

9.4 ENGINE

Refer to the separate engine manual for engine maintenance instructions.

Maintain engine oil as instructed in the separate engine manual packed with your unit. Read and follow

instructions carefully.

Service the air filter cleaner as per the separate engine manual under normal conditions.

Clean every few hours under extremely dusty conditions. Poor engine performance and flooding usually

indicates that the air cleaner should be serviced.

To service the air cleaner, refer to the separate engine manual packed with your unit.

The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is recommended

at the start of each mowing season. Check the engine manual for correct plug type and gap specifications.

Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to

permit proper air circulation, which is essential for engine performance and life. Be certain to remove all grass,

dirt and combustible debris from the exhaust area.

10. CHARGING THE STARTER BATTERY

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cobra RM46SPCE Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info