Bedienungsanleitung Cola Medea (Seite 38 von 132) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

668899

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

38 MEDEA – MEDEA LUX

Every installation must provide for an easily accessible technical space for periodical maintenance.

The stove is provided with 4 adjustable feet to facilitate positioning on not perfectly flat floors. To adjust the height,

tilt the stove slightly and turn the feet as required.

The stove is supplied with the ambient sensor fixed through a wrapper on the back of the stove; we recommend to

remove the wrapper and to locate the sensor in the best position possible as to improve the temperature registration

in accordance with the ambient context and the length of the cable.

As for temperature registration done at a certain distance we reccomend to install the ambient thermostat/ambient

programming clock-thermostat – see. par.4.8.

- The stove cannot be installed in bedrooms, bathrooms and in general in rooms where

another heating unit is already installed without an independent air inflow.

- With wooden floors, install a floor protection base in conformity with the current regulations.

- Suitable fire-prevention devices should be arranged for any eventuality.

- Do not install the stove in places with an explosive atmosphere.

2.3 Air inlet

The stove air inlet pipe or intake is located at the back and is round and 50 mm in diameter.

A quantity of air at least equal to that necessary for combustion must flow in the room where the stove is installed;

therefore the combustion air necessary to ensure correct operation of the stove must be drawn:

►

from the room, provided there is a wall air inlet near the stove, communicating with the outside and of minimum

area 100 cm² suitably protected externally by a grille;

►

or with direct connection to the outside with an appropriate pipe having a minimum internal diameter of 50 mm

and maximum length of 1.5 m, provided with antiwind protection at the end (down bend).

The air inflow can also be obtained from a room adjoining that of installation, provided the flow can occur freely

through permanent openings to the outside; the room must not be used as a garage, for storing combustible

materials or for activities with fire risk.

2.4 Fume exhaust

The fumes can be exhausted through a connection to a conventional flue or an external duct with double wall or

insulated pipe.

The fume exhaust connections must guarantee a minimum draught of 10 Pa so that the evacuation of fumes is

assured in case of a temporary power failure.

- The installer must check the efficiency and state of the flue and its conformity with the

local, national and European regulations.

- Certified pipes and connections with adequate seals guaranteeing their tightness must be used.

- In case of fire, shut down the stove, promptly call the fire department, and avoid continual

attempts

to extinguish it.

- Clean the flue and respective connection at least once a year.

Floor protection base

Air inlet

min. 100 cm²

A = 300 mm

B = 200 mm

C = 1500 mm

D = 200 mm

Antiwind

grille

Flue

Inspection door on

flue

T union with

inspection cap

Flue connection

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cola Medea Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info