Bedienungsanleitung Cola Medea (Seite 42 von 132) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

668899

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

42 MEDEA – MEDEA LUX

4 STOVE USE

4.1 Introduction

The pellet stove has the advantage of combining heat from a wood flame with the convenience of automatic

management of temperature and the possibility of weekly programming of lighting and shutdown.

For safe and reliable use, observe the following:

 when lighting the stove the first time, unpleasant odours may be created, therefore ensure good ventilation

of the room, especially during the first period of operation;

 the hopper must only be filled with pellets, without allowing the bag to come into contact with the hot

surfaces of the stove;

 do not put any type of fuel other than recommended wood pellets in the hopper;

 the unit must not be used as a waste incinerator;

 the stove must work only with the fire door always closed;

 the fire door seals should be checked periodically to ensure air tightness;

 to ensure efficient and correct operation, it is necessary to clean the brazier whenever pellets are loaded;

 when lighting the stove for the first time, make sure to allow it to get hot gradually without overheating;

 during lighting, operation and shutdown, the stove may creak a little due to the heat expansion.

4.2 Control panel

The control of the stove occurs through the use of a control panel provided with four buttons and an LCD display.

The panel allows activation and deactivation, adjustment during operation and the setting of management programs

and maintenance.

Given below is the control panel and the main functions of the buttons:

LCD display

P1: Button for setting the room temperature and

scrolling the various menus

P4: On/Off button and for exiting the MENU

IR receiver

P2: Button for setting the power and scrolling

the various menus

P3: Button for accessing the MENU

Indication of activated functions

4.3 Lighting

Before lighting of the stove, check the following points:

− make sure to have read and understood the instructions in the manual;

− the hopper must be filled with pellets;

− the combustion chamber must be clean;

− the brazier must be completely free, clean of any combustion residuals and properly positioned in the

brazier holder;

− check the hermetic closure of the fire door and ash drawer;

- At first lighting, remove from the stove firebox and glass any components which could burn

(instructions/label).

- Any lightings done after long idle periods require complete cleaning of the combustion chamber and

the removal of any pellets left in the hopper, in being damp fuel no longer suitable for combustion.

To light the stove, press button P4 on the panel for a few seconds. The message START will appear on the LCD

display. This phase is automatic and is managed completely by the electronic control, without any possibility to

intervene on the parameters.

The stove carries out the startup phases in sequence according to the procedure defined by the parameters,

reaching the work condition. After a certain time, if the fume temperature has not reached the minimum permissible

value, the stove goes in alarm status.

- Do not use flammable liquids to light the unit.

- In case of persistent failed lighting, contact the Service Centre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cola Medea Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info