Bedienungsanleitung Cola Medea (Seite 46 von 132) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

668899

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

46 MEDEA – MEDEA LUX

Then set as follows:

− external thermostat: set a temperature of 7°C;

− external chronothermostat: set a temperature of 7°C, disable the chrono functionality in the menu 03 and

set the STANDBY function to ON. When the set temperature is reached, the stove will shut down and not

go to modulation.

In this case, however, it is advisable to use the stove time programming function and only the external

chronothermostat set temperature function.

In fact, only with this joint setting is it possible to set STANDBY to ON or OFF, obtaining respectively

modulation or shutdown when the SET temperature is reached and likewise obtaining shutdown and lighting

according to the set time programming.

When the external thermostat requests stove operation, the corresponding symbol will light up on the display.

4.9 Idle period (end of season)

If the stove is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows

- remove all the pellets from the hopper;

- disconnect the power and remove the power cable;

- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;

- protect the stove from dust with suitable covering;

- store in a dry and safe place protected from atmospheric agents.

5 STOVE CLEANING

Stove cleaning is very important to ensure correct operation and to prevent: blackening of the glass, poor

combustion, deposits of ash and unburnt products in the brazier, reduced thermal efficiency.

The stove must only operate with the fire door closed.

The fire door seals must be checked periodically to prevent any air from entering; the combustion chamber and

pellet duct work in a negative pressure and the fume exhaust in a positive pressure.

Routine cleaning is normally carried out by the customer following the instructions in the manual, whereas

extraordinary maintenance, at least once a year, must be performed by the authorised Service Centre.

- Cleaning operations for all parts must be carried out with the stove unplugged and

cold;

- Dispose of cleaning waste in accordance with the current local regulations;

- The stove must not be operated without its cladding;

- Avoid the creation of smoke and unburnt products during lighting and/or normal operation.

Given below are the control and/or maintenance operations for correct stove use and operation.

Parts / Period

Type of cleaning

1 day

routine

cleaning

2-3 days

routine

cleaning

1 month

routine

cleaning

2-3 months

routine

cleaning

year

extraordinary

cleaning: carried out

by the Service Centre

Brazier

■

Ash compartment-pan

■

Glass

■

Baffle - fume exchanger

■ ■

Manifold - fume extractor

■ ■

Glass - door seal

■

Pipe - flue connection

■

5.1 Cleaning the brazier

Remove the brazier and the ash deposited in the combustion chamber and brazier holder. A suitable vacuum

cleaner may be used for this purpose. This operation must be carried out daily, especially in case of accumulated

unburnt matter, to ensure perfect combustion conditions, since the brazier holes allow the flow of combustion air.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cola Medea Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info