Bedienungsanleitung Cola TERMO POWER 30S (Seite 65 von 175) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

669018

Zoom out

Zoom in

Vorherige Seite

1/175

Nächste Seite

T-POWER30_T-POWER 30S

5.4 Cleaning the fume extractor and combustion chamber

The combustion chamber must be cleaned at least once a year, removing all combustion residuals from the internal

fume pipes and flueways. To carry out this operation, it is necessary to remove the stove top cover, the heating

chamber cover and the bottom inspection door, undoing the relevant fixing screws, then clean the turbulators and

internal fume pipes.

Also, make sure to clean the fume extractor located under the bottom fume manifold accessed through the

inspection door opening.

Every 3-4 months clean the inside walls (insulating-refractory) of the combustion chamber using suitable equipment

(brushes) and replace the vermiculite wall if necessary.

Every 1800 hours of operation, by means of a message 'SERVICE DUE', the stove signals the need for

extraordinary maintenance (not under warranty) to be performed by qualified personnel who will carry out complete

cleaning and reset the message.

Any knocking or forcing can damage the fume extractor, making it noisy during

operation; therefore it is advisable to have this operation carried out by qualified personnel.

5.5 Cleaning the air flow meter

The air flow meter (it measures the flow of combustion air) installed inside the inlet pipe requires periodical internal

cleaning every 3-4 months, using suitable equipment (blowing compressed air or suitable brushes).

5.6 Cleaning the ceramic surfaces

The ceramic tiles are handicraft products and therefore may have minor surface imperfections such as tiny spots or

slight colour differences. It is advisable to use a soft dry cloth to clean the ceramic surfaces; the use of detergents

could highlight any flaws.

5.7 Cleaning the flue - flue connection

The flue connection must be cleaned at least once a year or whenever necessary.

Cleaning requires the suction and removal of the residuals in all the vertical and horizontal sections as well as the

bends from the stove to the flue.

It is advisable to also clean the flue every year, to ensure correct and safe evacuation of fumes.

5.8 Cleaning the exchangers with turbulator-shaker device

The fume ducts inside the heating chamber must be cleaned

at least once a day by operating the two knobs repeatedly with

an upward and downward movement.

Carry out this operation with the stove off and cold.

6 MAINTENANCE

6.1 Introduction

Operations on the internal parts of the stove must be carried out by qualified personnel. Contact the nearest

authorised service centre.

Make sure the stove is unplugged and cold before carrying out any work on it.

RH - LH control knobs of the turbulator-

shaker device in heating stove operation

low position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cola TERMO POWER 30S Seite 65

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info