MACHINE PREPARATION
11. FIXING THE HANDLEBARS
For packaging purposes the handlebars are supplied folded; they must now be put in the working
position. Proceed as follows:
1. raise the handlebars by pulling the lever - indicated by the arrow - upwards
2. place the machine in the working position
3. attach the recovery tank to the handlebars tube by means of the two hooks
4. insert the tubes in the connectors that emerge from the recovery tank nut
12.
SOLUTION TANK
Completely empty the recovery tank each time the solution tank is filled, and make sure the cap is
properly in place (A).
Verify that the quick connection is correctly connected (B).
13.DETERGENT SOLUTION
Proceed as follows to fill the solution tank:
1. Make sure that the recovery tank is empty
2. Make sure the main switch is off
3. Remove the inlet cap located on the rear right side of the machine.
4. Fill it with clean water at a temperature not exceeding 50°C.
Add the liquid detergent to the tank in the concentration and manner indicated on the
detergent manufacturer's label. The formation of excess foam could damage the
suction motor, so only use the minimum amount of necessary detergent.
ATTENTION: Acid or alkaline detergents can be used with pH values between
4 and 10 and that do not contain: oxidising agents, chlorine or bromine,
formaldehyde, mineral solvents.
