521985
14
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
CSB200 Class B AIS
R2.0 27
'Update' button should be clicked to send new settings to
the AIS transponder.
Alarm output options
By default the AIS transponder will output the status of all alarms every
minute using AIALR sentences. The unit can be optionally configured to
only output active alarms using the radio buttons. The 'Update' button
should be clicked to send new settings to the AIS transponder.
CSB200 Class B AIS
R2.0 28
USING THE CSB200
Switching on
When the 12VDC supply is switched on the green ON LED will light and
the other six LED’s visible on the front panel of the unit will illuminate
twice for a period of one second on each illumination. The Status, TX Off
and TX LEDs will then go out. The green RX LED will flash when it is
receiving data from other AIS units.
When the internal GPS is locked the yellow LED will go out and the
green Status Led will light; note that this process may take several
minutes depending on the switch-on state of the GPS receiver. The red
TX LED will flash momentarily every time the unit transmits.
NOTE If the unit has not been programmed with an MMSI number the
green RX, yellow Timeout and red Error LED will remain on.
Warning and Fault States
If the unit has not been able to transmit a position report during the last
expected two reporting intervals (i.e. the nominal reporting interval cannot
be maintained for operational reasons such as a Message 23 quiet
period, high channel load conditions, etc) the yellow LED will illuminate.
This is a warning condition only and indicates that your vessels
position is not currently being reported to other vessels. Reception of
other vessel AIS information by the CSB200 is not affected. When the
unit is able to commence reporting the yellow LED goes out.
If a fault occurs the red Error LED will illuminate. This may illuminate
briefly if the power supply is interrupted or if the VHF antenna
characteristics are briefly affected.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Comar CSB200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info