Intended Use
Electrodes are intended for use as a
disposable, conductive adhesive interface
between the patient’s skin and the electrical
stimulator.
Directions For Use
Application
1. Clean skin thoroughly prior to each
application of electrodes. Electrodes do
not stick well if any lotion, oil, make-up,
dirt, etc. is left on skin.
2. Insert the pins of the lead wire from the
device into the electrode wire
connectors.
3. Remove the electrodes from the
protective liner and apply firmly to
the skin. Adhesion improves when
electrodes reach skin temperature.
Removal
1. Make sure device is turned off. Lift at the
edge of electrodes and peel. DO NOT
pull on the lead wires when removing
electrodes from the release liner or skin.
You may damage the electrodes if you
do so.
2. Place the electrodes on the liner and
remove the lead wire by twisting and
pulling at the same time.
Care and Storage
1. Between uses, store the electrodes in the
resealable bag in a cool, dry place.
2. The life of the electrodes varies
depending on skin conditions, storage,
amount of use, type of stimulation and
stimulation site. Electrode life may be
extended by carefully following the
application instructions above and
below.
3. Avoid electrodes from being exposed to
direct sunlight or extreme humidity.
Recommended storage conditions:
41º – 86º, Relative Humidity: 40 – 70%
4. DO NOT leave the electrodes uncovered
in air as this will decrease the viscosity
and performance of the product.
Caution
1. Read instructions carefully prior to use.
2. The electrodes are intended for single
patient use only.
3. DO NOT apply to broken skin. Should
skin rash occur, discontinue use and
contact your physician. DO NOT use
while driving a motorized vehicle or
while operating machinery.
4. DO NOT disassemble or alter electrodes.
5. For use with TENS and EMS type
devices only.
6. DO NOT use on children or infants.
These electrodes have not been
evaluated for pediatric use.
For questions or comments regarding
product, please contact 800-376-7263.
Exp Date: YYYY-MM-DD
Lot #:
Size: 2”x2” White Cloth
Shape: Square
Qty: 4/pk
Manufactured for: Compass Health Brands Corp.
Middleburg Heights, OH 44130
• 2”x2” Square – White Cloth Electrode
• Self-Adhesive Electrode Gel
• Premium Quality
• Reliable & Reusable
• Flexible
• 4 Electrodes Per Package
1. When the device is turned on, check the low battery indicator.
corner of the device.
2. When the battery is low and the battery indicator blinks stating that
the battery needs to charge. Turn off the unit.
3. The Lithium battery can be recharged by connecting the USB side of
connecting the other side of the cord to the bottom of the device.
to two hours to complete a full charge.
times. Unplug the charger from power outlet when charging is complete.
charging. DO NOT use the device while charging.
