Bedienungsanleitung Compex Ayre (Seite 9 von 176) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch)

820621

Zoom out

Zoom in

Vorherige Seite

1/176

Nächste Seite

RECOMMENDED SEPARATION DISTANCES BETWEEN PORTABLE AND MOBILE RF COMMUNICATIONS

EQUIPMENT AND THE DEVICE.

The device is intended for use in an electromagnetic environment in which radiated RF disturbances are

controlled. The customer or the user of the device can help prevent electromagnetic interference by maintaining

a minimum distance between portable and mobile RF communications equipment (transmitters) and the device

as recommended below, according to the maximum output power of the communications equipment.

Rated maximum output

power of transmitter (W)

Separation distance according to frequency of transmitter (m)

150 KHZ TO 80 MHZ 80 MHZ TO 800 MHZ 800 MHZ TO 2.5 GHZ

0.01 0.12 0.12 0.23

0.1 0.38 0.38 0.73

11.2 1.2 2.3

10 3.8 3.8 7.3

100 12 12 23

For transmitters rated at a maximum output power not listed above, the recommended separation distance d in

meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the

maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.

NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.

NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption

and reflection from structures, objects and people.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

A. This device may not cause harmful interference, and

B. This device must accept any interference received, including interference that may cause undesired

operation.

The subject device has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation.

The product generates, uses, and can radiate radio frequency energy and, if not installed and used accordance

with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that the interference will not occur in a particular installation. If the product

does cause harmful interference to radio or television reception, which can be determined by turning the

product on or off, the user is encouraged to try to correct the interference by one or more of the following

measures:

A. Reorient or relocate the receiving antenna;

B. Increase the separation between the product and the receiver;

C. Consult the dealer or an experienced radio / TV technician for help;

D. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Changes or modifications to this product not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Compex Ayre Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info