Bedienungsanleitung Concept VP4140 (Seite 30 von 71) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch)

802899

Zoom out

Zoom in

Vorherige Seite

1/71

Nächste Seite

58 59

ENEN

VP4140 | VP4150 | VP4151 | VP4160 VP4140 | VP4150 | VP4151 | VP4160

LED INDICATOR

State LED indicator colour

On Blue

Low battery Blue ﬂashing

Empty battery Red ﬂashing

Charging Red

Charging completed Blue

Bad battery (charging) Red and blue ﬂash alternately

Battery care

To prolong the life of the vacuum cleaner battery, follow these instructions:

Do not leave the vacuum cleaner fully charged or completely discharged for a long time.

Prolonged discharged of the battery will result in loss of its capacity.

Do not let the vacuum cleaner to be completely discharged.

It is ideal to keep the capacity of the battery between 20 % - 80 %.

USE

Operation of the rod vacuum cleaner

1. Press the on/oﬀ button to turn on the rod vacuum cleaner.

2. During operation, press the ECO speed button and select between high speed and ECO speed. At high speed, the

suction power of the appliance will be at its maximum, while the ECO speed mode will provide less noise and longer

operating times.

3. During operation, the LED indicator on the rotating brush nozzle lights up.

4. If the appliance is standing in the upright position, always turn the rod vacuum cleaner oﬀ as the bristles could

damage the ﬂoor or the carpet.

5. If you are not using the appliance, it is recommended to store it in an upright position leaning up against the wall.

Do not let children play with the appliance.

Operation of the hand-held vacuum cleaner

1. Press the button on the hand-held vacuum cleaner and release the vacuum from the rod vacuum cleaner. Press the

on/oﬀ button to turn on the hand-held vacuum cleaner. The hand-held vacuum cleaner starts to vacuum.

2. Vacuum the surface in any direction until the surface is clean.

3. Press the on/oﬀ button to turn oﬀ the hand-held vacuum cleaner. Before turn oﬀ, turn the front of the hand-held

vacuum cleaner upwards to prevent the dust from falling out of the dust cup.

4. Before vacuuming, empty and clean the dust cup.

5. Insert the hand-held vacuum cleaner back into the rod vacuum cleaner.

CLEANING AND MAINTENANCE

Emptying the dust cup

Empty the dust cup after each use or when the dust level exceeds the maximum level. Always switch oﬀ the appliance

before cleaning it.

• Press the release button on the top of the vacuum cleaner, release the dust cup, empty it and remove the ﬁlter

holder from it.

• Press both sides of the external ﬁlter and remove the ﬁlters from the dust cup. Dump the dirt.

• Wash the ﬁlters. Allow them to dry before reassembly.

NOTE: Do not clean the vacuum cleaner with thinner or chemical solutions, as this will damage the appliance

• Insert the internal and external ﬁlters back into the dust cup Make sure you dry the inside of the dust cup.

• Place the dust cup back into the hand-held vacuum cleaner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Concept VP4140 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info