Bedienungsanleitung Concord Vario XT -5 (Seite 10 von 15) (Englisch)

768261

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

32 3332 33

6b | Guide the lap belt on both sides through the lap belt guide (04)

to the lock and close it, same as with an adult. (An audible click will

signal proper locking).

Then guide the diagonal belt on the lock side over the lap belt guide

and on the other side through the provided shoulder belt guide (10).

6c | To adjust the CONCORD VARIO to the size of the child, press the

headrest (01) slightly downwards.

Press the size adjustment control (09) located on the upper part of

the backrest, and move the headrest (01) into the desired position

while pressing the control knob (09).

The CONCORD VARIO can be infinitely adjusted in size and is locked

in the current position by letting go of the control knob (09).

The shoulder harness guide (10) should be situated slightly above

the shoulder of the child. The shoulder harnesses should lie in the

middle between the neck and the outer edge of the shoulder.

Tighten the belt for the lap belt and diagonal belt to fit snug and be

sure that the belts are not twisted. Here, the lap belt should lie as

low as possible.

If your vehicle is equipped with seat belt height adjustment, then

bring it into the correct height.

When getting out, it is sufficient to only open the lock and pass the

strap in front of the child.

Check the correct position of the seat belts before each use.

Please contact CONCORD directly if you have problems mounting

the seat. The seat belts must run through the belt guides marked in

red on the seat. The seat belt must not be laid out in any other way.

_ USING THE THE CONCORD VARIO FOR 15-36 KG

When using a CONCORD VARIO for a child of 15-36 kg

• The seat height adjustment (03) must be set to the lowest

position.

• The 5-point belt system must be stored under the cover of

the seat squab (for this, refer to „STORING THE 5-POINT BELT

SYSTEM“)

• The CONCORD VARIO should always be secured in the vehicle

with the ISOFIX system and in combination with the TOP TETHER

(see „INSTALLATION OF THE CONCORD VARIO WITH ISOFIX“).

An overview, current at the time of your seat production, of the

vehicle and vehicle seats, which are suitable for using the ISOFIX

system as additional stabilization, can be found in the handout

„CAR FITTING LIST“. For latest updates, please visit www.

concord.de.

CAUTION!

The child and the seat without a child must always

be secured using the vehicles own 3-point safety

belt.

6a | Place the CONCORD VARIO in drive direction onto the seat or

the seat bench. The CONCORD VARIO should align with the seat and

backrest with as much direct contact as possible. In vehicles with

standard headrests, a readjustment of the headrest or its removal

will allow a better mounting position of the car seat.

Please remember to readjust or reinstall the headrest in the correct

position, if an adult is to sit in that place instead.

Place your child onto the seat as far back as possible.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Concord Vario XT -5 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Concord Vario XT -5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info