652338
70
Zoom out
Zoom in
Vorherige Seite
1/80
Nächste Seite
70 Mounting and installation work
Connecting the voltage supply via Option CVI (for 3 phase/neutral single voltage system)
F3
Q3
L2 L3 PENL1
L2 L3L1
N PEL1
MAINS SUPPLY
L N SC1SC2PEPE
MODULE B
X7
X1
MAINS S
L N SC1
MODULE B
X7
X1
L1 L2 L3
K1
F3
Q3
L2 L3
PE
L1
L1 L2 L3
K1
L1
THV
L2 L3
400-415 V/3~N/50..60 Hz 400-415 V/3~/50..60 Hz
6.3 A, slow acting
Option CVI
Control compartment
(Module B)
Control compartment
(Module A)
Supply cable
(Module A / Module B)
The voltage supply (L1, L2, L3, N and PE) is to be connected in accordance with the wiring diagram
to the corresponding terminals of the option CVI. The supply wiring is to be fed into the unit via the
clamp strap on the bottom of the unit.
Note: On double units consisting of two housings the heating voltage supply for module B is connected
directly to the corresponding terminals of the main contactor "K1" or to the corresponding terminals of
the optional terminal strip "THV". The control voltage supply to module B is established via the supply
cable connected to the terminal strips "X7" on the driver boards of module A and module B.
The installation of the fuses "F3" and the electrical isolator "Q3" (all pole disconnecting device with
a minimum contact clearance of 3 mm, supplied by others) in the mains supply line are mandatory.
Note: a table with the values for the fuses "F3" is to be found in chapter 5.7.7.
The electrical isolator must be mounted in direct proximity of the control compartment (max. distance
1 m) and must be easily accessible in a height between 0.6 m and 1.9 m (recommended: 1.7 m).
CAUTION! Make sure the voltage indicated on the specication label meets the local mains voltage.
Otherwise, do not connect the unit.
The cross-section of the mains cable must comply with the applicable local regulations.
Connecting the blower pack BP
See separate documentation for blower pack BP.
70

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Condair RS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Condair RS

Condair RS Bedienungsanleitung - Englisch - 80 seiten

Condair RS Bedienungsanleitung - Holländisch - 80 seiten

Condair RS Installationsanweisung - Holländisch - 76 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info