Bedienungsanleitung Constructa CA333350 (Seite 26 von 36) (Deutsch, Englisch, Holländisch, Französisch)

755337

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Cleaning and care

The information in this section provides help on how best to

care for your hob.

Suitable maintenance and cleaning products can be purchased

from the after-sales service or in our e-Shop.

Ceramic

Clean the hob after each use. This will prevent spills from

burning onto the ceramic.

Only clean the hob when it has cooled down sufficiently.

Use only cleaning agents which are suitable for ceramic. Follow

the cleaning instructions on the packaging.

Never use:

■Undiluted washing-up liquid

■Detergent intended for dishwashers

■Scouring agents

■Harsh cleaning agents such as oven spray or stain remover

■Abrasive sponges

■High-pressure cleaners or steam jet cleaners

Ground-in dirt can be best removed with a glass scraper,

available from retailers. Please note the manufacturer's

instructions.

You can also obtain a suitable glass scraper from our after-

sales service or from the e-Shop.

Hob surround

To prevent damage to the hob surround, please observe the

following instructions:

■Use only warm, soapy water.

■Do not use harsh or abrasive agents.

■Do not use the glass scraper.

Rectifying faults

Malfunctions often have simple explanations. Please read the

following notes before calling the after-sales service.

After-sales service

Our after-sales service is there for you if your appliance should

need to be repaired. We are committed fo find the best solution

also in order to avoid an unnecessary call-out.

E number and FD number:

Please quote the E number (product number) and the FD

number (production number) of your appliance when

contacting the after-sales service. The rating plate bearing

these numbers can be found on the appliance certificate.

Please note that a visit from an after-sales service engineer is

not free of charge, even during the warranty period.

Please find the contact data of all countries in the enclosed

customer service list..

Trust the expertise of the manufacturer, and rest assured that

the repair will be carried out by trained service technicians

using original spare parts for your domestic appliance.

Indicator Fault Action

Blank There is no power supply. Check the household fuse for the appliance. Check whether there is a power

cut by trying other electronic appliances.

“ is flash-

ing The controls are damp or an object is

resting on them. Dry the controls or remove the object.

“§ +

number Electronic fault. Switch the appliance off and back on again after about 30 seconds using

either the household fuse or the circuit breaker in the fuse box. Contact the

after-sales service if this appears in the display again.

”ƒ The electronics have overheated and

have switched off the corresponding

hotplate.

Wait until the electronics have cooled down sufficiently. Then touch a control

for the hotplate.*

”… The electronics have overheated and

have switched off all hotplates. Wait until the electronics have cooled down sufficiently. Then touch any con-

trol.*

”‰ The hotplate was in operation for too

long and has switched itself off. You can switch the hotplate back on again immediately.

* Do not place hot pans close to or on the control panel

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Constructa CA333350 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info