Bedienungsanleitung Constructa CD689860 (Seite 20 von 60) (Deutsch, Englisch, Holländisch, Französisch)

715171

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Cleaning and maintenance

Cleaning and mai nt enance

: Risk of burns!

The appliance becomes hot during operation. Allow the

appliance to cool down before cleaning.

: Risk of electric shock!

Penetrating moisture may result in an electric shock. Clean the

appliance using a damp cloth only. Before cleaning, pull out the

mains plug or switch off the circuit breaker in the fuse box.

: Risk of electric shock!

Do not use any high-pressure cleaners or steam cleaners,

which can result in an electric shock.

: Risk of injury!

Components inside the appliance may have sharp edges. Wear

protective gloves.

: Risk of injury!

Risk of trapping body parts when opening and closing the

glass front. Do not reach into the area behind the glass panel,

and keep your fingers away from the hinges.

Cleaning agents

To ensure that the different surfaces are not damaged by using

the wrong cleaning product, follow the instructions in the table.

Do not use any of the following:

■ Harsh or abrasive cleaning agents, e.g. scouring powder or

liquid scouring cleaner,

■ Cleaning products with a high alcohol content,

■ Hard scouring pads or cleaning sponges,

■ Pressure washers or steam cleaners,

■ Cleaning products that dissolve limescale,

■ Aggressive all-purpose cleaning products,

■ Oven spray.

Note: Wash new sponge cloths thoroughly before use.

Note: Follow all instructions and warnings included with the

cleaning products.

--------

Removing metal grease filter

1. Open the glass front slowly and fully. Hold the glass front in

the centre when doing so, gripping it firmly.

2. Open the lock and swing down the metal grease filter. When

you do this, take hold of the metal grease filter from

underneath with your other hand.

3. Take the metal grease filter out of the holder.

Notes

■ Fat may accumulate in the bottom of the metal grease filter.

■ Hold the metal grease filter level to prevent grease from

dripping out.

Area Cleaning products

Stainless steel Hot soapy water:

Clean with a dish cloth and then dry with

a soft cloth.

Clean stainless steel surfaces in the

direction of the grain only.

Special stainless steel cleaning prod-

ucts are available from our after-sales

service or from specialist retailers.Apply

a very thin layer of the cleaning product

with a soft cloth.

Painted surfaces Hot soapy water:

Clean using a damp dish cloth and then

dry with a soft cloth.

Do not use stainless steel cleaner.

Aluminium and

plastic

Hot soapy water:

Clean with a soft cloth.

Glass Glass cleaner:

Clean with a soft cloth. Do not use a

glass scraper.

Controls Hot soapy water:

Clean using a damp dish cloth and then

dry with a soft cloth.

Risk of electric shock caused by pene-

trating moisture.

Risk of damage to the electronics

caused by penetrating moisture. Never

clean controls with a wet cloth.

Do not use stainless steel cleaner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Constructa CD689860 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info