Bedienungsanleitung Constructa cf 130250 (Seite 47 von 52) (Deutsch, Englisch, Holländisch, Französisch)

331061

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.

m Risk of burning due to hot components in the cooking

compartment!

Wait until the cooking compartment has cooled down.

1. Push the hook-in rack upwards at the front and unhook to the

side (figure A).

2. Pull the hook-in rack forwards at the rear and unhook to the

side (figure B).

3. Clean the hook-in rack with washing-up liquid and a sponge

or brush.

4. Align the hook-in rack with the indentation (a) facing

downwards, so that the shelf heights match.

5. Insert the hook-in rack at the rear as far as it will go and push

to the rear (figure C).

6. Insert the hook-in rack at the front as far as it will go and

push downwards (figure D).

Faults and repairs

In the event of a fault, check the tips in the following table

before calling the after-sales service.

m Risk of electric shock!

Work on the appliance electronics may only be performed by

an expert. Disconnect the appliance from the power supply.

Switch off the circuit breaker or take out the fuse in the

household fuse box.

Replacing the oven light bulb

Replace faulty oven light bulbs.

You can obtain replacement light bulbs from customer service

or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to

300 °C. Only use these oven light bulbs.

m Risk of electric shock !

Disconnect the appliance from the power supply. Switch off the

circuit breaker or remove the fuse from the household fuse box.

1. Place a tea towel in the cold cooking compartment to prevent

damage.

2. Turn the glass cover anticlockwise and remove it.

3. Replace the oven light bulb with a bulb of the same type.

4. Screw on the glass cover again.

5. Remove the tea towel and switch on the circuit breaker.

Note: If the glass cover cannot be unscrewed: use rubber

gloves to turn it. You can order a special removal tool through

the after-sales service (order no. 613634)

A B

C D

Problem Possible cause Remedial action

Electrical operation is malfunctioning (e.g.

indicator lamps do not light up)

Faulty fuse Check fuses in the fuse box and replace if

necessary

Liquid or thin dough runs to one side Appliance not installed level Check the appliance installation (see the

Installation instructions)

Smoke is generated during roasting or

grilling

Fat is burning on the grill element Continue grilling or roasting until the fat on

the grill element is burnt away

Wire rack or universal pan inserted

incorrectly

Place the wire rack in the universal pan

and insert them together at a lower shelf

height

High levels of condensation are generated

in the cooking compartment

Normal occurrence (e.g. when baking

cakes with very moist toppings or roasting

a large joint)

Open the appliance door occasionally

during operation

Enamelled accessories have light, matt

marks

Normal occurrence caused by dripping

meat or fruit juices

Not possible

Door panels are misted up Normal occurrence caused by

temperature differences

Heat the appliance up to 100 ºC and then

switch off again after 5 minutes

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Constructa cf 130250 Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info