Bedienungsanleitung Constructa CF030250 (Seite 44 von 72) (Deutsch, Englisch, Holländisch, Französisch)

755458

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Removing and refitting the door panels

The glass panels can be removed from the oven door to allow

more thorough cleaning.

Removal

1. Removing the oven door See the section Removing the oven

door. Lay the oven door on a cloth with the handle facing

downwards.

2. Remove the cover from the top of the oven door. To do this,

press with your fingers on the left and right-hand side. Pull

out the cover (Fig. A).

3. Raise the top panel and pull it out (Fig. B).

Clean the panels with glass cleaner and a soft cloth.

: Risk of injury!

Scratched glass in the appliance door may develop into a

crack. Do not use a glass scraper, sharp or abrasive cleaning

aids or detergents.

Fitting

1. Hold the top glass panel firmly by the sides and slide it in

towards the back at an angle. The panel must be inserted

into the openings on the lower side. The smooth surface must

face outwards, while the roughened side must be on the

inside. (Fig. A).

2. Place the cover on the top of the oven door and press in

place. Make sure that the grooves along the sides lock into

position.

3. Refitting the oven door See the section Refitting the oven

door.

Do not use the oven again until the panels have been

correctly fitted.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table

before calling the after-sales service as you may be able to

remedy the fault yourself.

Malfunction table

If your meal is not successful, please refer to section . We have

tested the recipe for you in our cooking studio. Here, you will

find useful cooking tips and tricks for cooking, baking and

roasting.

: Risk of electric shock!

Repairs that are not carried out properly are dangerous.

Repairs must only be performed by one of our after-sales

service technicians.

Caution!

If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons in

order to avoid a hazard.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-

resistant, 40 watt spare bulbs can be obtained from our after-

sales service or a specialist retailer. Only use these bulbs.

: Risk of electric shock!

Switch off the circuit breaker in the fuse box.

1. Place a tea towel in the oven when it is cold to prevent

damage.

2. Unscrew the glass cover by turning it anti-clockwise.

3. Replace the bulb with one of the same type.

4. Screw the glass cover back in.

5. Remove the tea towel and switch on the circuit breaker.

Glass cover

You must replace a damaged glass cover. Suitable glass

covers may be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.

Malfunction Possible cause Remedy/information

The oven does

not work. The circuit

breaker is

defective.

Look in the fuse box to see

if the circuit breaker is

defective.

Power cut. Check whether the kitchen

light and other kitchen

appliances are working.

Oven not hot. Dust on the

contacts. Turn the control knobs sev-

eral times to the left and

right.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Constructa CF030250 Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info