Bedienungsanleitung Convair MILLENIA - ILL863-A (Seite 10 von 16) (Englisch)

470070

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Millenia series Portable Evaporative Cooler

3.6 Fan/pump not running

fast enough on low speed.

3.7 Pump drive belt faulty

or broken.

3.6.1 Check that supply voltage is up to correct level.

3.6.2 Fan and pump will pick up speed slightly as the motor

reaches normal operating temperature. Allow the cooler to

run for 30-60 minutes and check again. If there is no

improvement have the cooler checked by a service agent.

3.7.1 Replace drive belt as shown on page 7.

4.1 Reservoir or Aspen

cooling pad dirty.

4.2 Water quality is poor.

4.1.1 Drain reservoir and fill the cooler with clean water. If it

still smells clean the reservoir and replace the Aspen cooling

pad or proceed to 4.2.1.

4.2.1 Add a little vanilla essence or perfume to the water.

4. Cooler makes bad

smell.

5.1 Dirt has accumulated

inside pump.

5.1.1 Proceed as in 3.5.1

5.1.2 Replace drive belt as shown on page 7.

5. Cooler makes

scraping or rattling

noise on new season

start up.

6.1 Too much water in

reservoir.

6.2 Water level indicator

not working.

6.1.1 Drain some water out (see page 7).

6.2.1 Remove the rear panel for access. Slide the indicator

up to the 'FULL' position then let it drop. If it fails to operate

have it checked by a service agent.

6. Water overflows from

reservoir.

7.1 Electrical fault.

7.1.1 Electrical parts must only be repaired and replaced by

Authorised Service Agents.

7. Cooler will not

operate at all.

8.1.1 If the power supply cord of this appliance is damaged it

must be replaced. Electrical parts must only be repaired and

replaced by Authorised Service Agents.

8. Damaged power

supply cord.

3. No cooling.

3.1 Cooling control is off.

3.2 Reservoir is empty or

nearly empty.

3.3 Weather is too humid.

3.4 Aspen cooling pad and

/ or pump inlet screen

blocked or dirty.

3.5 Pump is not working

properly.

3.1.1 Turn cool knob to 'COOL'.

3.2.1 Fill with water again until water level indicator is at the

'FULL' position. Water capacity is 14 litres

3.3.1 Turn cool knob to '0' and use cooler as a fan only.

3.4.1 Clean parts - see maintenance page 6.

3.5.1 The pump is NOT a separate electric pump. It is

connected to the fan motor and is driven mechanically. Turn

the cooler off and completely drain the reservoir. Refill with

water. Switch fan knob to high speed (3), turn the cool knob

to 'COOL',run the cooler for 10-15 minutes non-stop. This will

help dissolve and flush out the dirt. The Aspen cooling pad

should now be wet. If the pad is not visibly wet and there is

no cooling, have the cooler checked by a service agent.

1. Cooler will not

operate at first.

2. Cooler stops

operating after running

for some time.

1.1 Power outlet or supply

faulty.

1.2 Wrong voltage.

2.1 Motor overheated

(safety cutout).

1.1.1 Switch on power outlet.

1.1.2 Check power supply.

1.1.3 Check power outlet.

1.2.1 Check that power supply is the same as specified on

the rating label.

2.1.1 Wait 30-45 minutes for motor to cool down and it will

restart automatically. If condition persists take the cooler to a

service agent.

TROUBLESHOOTING

CONDITION POSSIBLE CAUSE REMEDY

9SEELEY INTERNATIONAL – OWNER’S MANUAL

When ordering spare parts, please specify the model / serial number

and colour of your cooler.

SPARE PARTS LIST

Item Description

1 Tank (includes drain plug)

2 Drain Plug

3 Rear Panel

4 Filter Pad

5 Front Grille Assembly

6 Badge - Front Grille

7 Window

8 Filler Door

9 Mid Panel Assembly

10 Inner Grille / Spreader Assembly

11 Inner Grille Door

12 Screws

13 Front / Rear Pillar (pair)

14 Base

14.1 Base - compact

15 Castor & Pintle Assembly

16 Control Panel

17 Control Box

18.1

Knob Mushroom

Knob Mushroom & Shaft Assembly

19 Water Valve Assembly

20.1

Switch (2006 - ) Millenia / Mastercool

Switch (2006 - ) Megacool

22 Lever Vane

23 Vane Link RH

24 Vane Link LH

25 Vane

26 Vane Bearing

27 Vane Link Motor

(Millenia / Megacool)

(Millenia / Megacool only)

(Mastercool only)

Item Description

28 Pad Clamp

29 Water Level Indicator

30 Float Assembly

31 Pump Assembly

32 Strainer

33 Vane Motor

34 Vane Motor Hub

36 Fan Pulley

37 Fan

38 Drive Belt

Spreader Hose

9.5 x 450

Pump Hose

9.5 x 890

42.1

Motor Rubbers White for Square Motor

Motor Rubbers Black for Round Motor

43.1

Electric Motor 230V 50Hz - Round

Electric Motor 230V 50Hz - Square

Capacitor 3.2uf for Motor

Plug & Cord Australia

Cord Grip - Flat Cord 4K-1

(Megacool only)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Convair MILLENIA - ILL863-A Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info