Bedienungsanleitung Cornutech 100601- HB1204BS (Seite 11 von 43) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

588218

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

6. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged

in any way; take it to a qualified serviceman.

7. Do not disassemble charger; take it to a qualified serviceman when service or repair is

required. Incorrect reassembly may result in a risk of electric shock or fire.

8. To reduce risk of electric shock, unplug charger from outlet before attempting any

maintenance or cleaning.

4.WARNING -RISK OF EXPLOSIVE GASES.

a. Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases

during normal battery operation. For this reason, it is of utmost importance that each time

before using your charger, you read this and follow the instructions exactly.

b. To reduce the risk of the battery explosion, follow these instructions and those published by

battery manufacturer and manufacturer of any equipment you intend to use in vicinity of battery.

Review cautionary markings on these products and on engine.

5. PERSONAL PRECAUTIONS

a. Someone should be within range of your voice, or close enough to come to your aid, when

you work near a lead-acid battery.

b. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or

eyes.

c. Wear complete eye protection and clothing protection. Avoid touching eyes while working

near battery.

d. If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters

eye, immediately flood with running cold water for at least 10 minutes and get medical attention

immediately.

e. NEVER smoke or allow a spark or flame in vicinity of battery or engine.

f. Be extra cautious to reduce risk of dropping a metal tool onto battery. lt might spark or short-

circuit battery or other electrical part that may cause an explosion.

g. Remove personal metal items such as rings, bracelets, necklaces, and watches when working

near a lead-acid battery. A lead-acid battery can produce a short-circuit current high enough to

weld a ring or the like to metal, causing a severe burn.

h. Use this charger for charging LEAD-ACID batteries only. lt is not intended to supply power

to a low voltage electrical system other than in an automotive application. Do not use battery

charger for charging dry-cell batteries that are commonly used with home appliances. These

batteries may burst and cause injury to persons and damage to property.

i. NEVER charge a frozen battery.

6. PREPARING TO CHARGE BATTERY

a.If it becomes necessary to remove the battery from the vehicle to charge, always remove

grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not

to cause an arc.

b. Be sure area around battery is well ventilated while battery is being charged. Gases can be

forcefully blown away, by using a piece of cardboard or other nonmetallic material such as a

fan.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cornutech 100601- HB1204BS Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info