Bedienungsanleitung Cramer 82ZT107 (Seite 20 von 422) (Alle Sprachen)

818973

Zoom out

Zoom in

Vorherige Seite

1/422

Nächste Seite

Error Code Description Solution

PMU10 Open circuit in battery pack in PMU Unconnected battery pack in battery compartment; machine

performance may be affected.

PMU11 PMU minor error A minor error in the battery compartment prevented the

blade system from starting. Wait for the system to recover,

and then reset the blade start switch.

PMU12 PMU critical error A major error in the battery compartment prevented the

drive and blade systems from starting. Restart the power

supply and try again.

PMU13 PMU no battery pack available Check that you are using the correct battery pack, and then

restart the power supply.

7 MAINTENANCE

7.1 MOWER BLADE MAINTENANCE

Check the mower blades daily. They are the key to power efficiency and well-groomed turf. Keep them sharp -- a dull

blade will tear rather than cut the grass, leaving a brown ragged top on the grass within a few hours. A dull blade also

requires more power. Replace any blade that is bent, cracked or broken.

WARNING

Never attempt to straighten a bent blade by heating, or weld a cracked or broken blade as the blade may break and

cause serious injury. Replace worn or damaged blades.

WARNING

Never work with blades while key is in the ignition switch. Turn key to “OFF” position, remove the battery packs

from the machine. Block up mower when you must work under it. Wear gloves when handling blades. Always check

for blade damage if mower strikes a rock, branch or other foreign objects!

DANGER

Touch-up sharpening can be done with a file. Check the blades for balance following grinding. A commercial

balancing tool is available through most hardware supply stores, or balancing can be done by placing the blade on

an inverted line punch or 12.7mm (1/2") bolt. Blade should not lean or tilt. While spinning the blade slowly, it should

not wobble. If blade is out of balance, true it up before reinstalling. Lay the blade on a flat surface and check for

distortion. Replace any distorted blade.

WARNING

• The blade sail (curved part) must be pointing upward toward the inside of the deck to ensure proper cutting.

• When mounting blades, rotate them after installation to ensure blade tips do not touch each other or sides of the

mower.

• Failure to correctly torque the bolt may result in the loss of the blade, which can cause serious injury.

• Mower blades are sharp and can cut. Wear gloves and use extra caution when servicing them.

7.1.1 REPLACE THE BLADE

See figure 17

1. Stop the motor, remove the start key, and set the parking brake.

2. Raise the height of the cutting deck to its highest position to allow access to blades.

NOTE

If necessary, raise the mower by placing on a lift or using a jack and jack stands, or remove the cutting deck as

described in the previous section to gain access to the blades.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cramer 82ZT107 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info