Bedienungsanleitung Create Winecooler Retro M (Seite 8 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

789647

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

8ENGLISH

INSTALLATION

INSTRUCTIONS

The temperature setting allows you to adjust it according to your needs:

• Adjust the temperature before tasting red wines: recommended temperature 16-17 °C.

• If the ambient temperature is higher or lower than the recommended temperatures, this

will have a negative impact on its performance. For example, placing the drive in an ex-

tremely hot or cold location can cause variations in the drive's internal temperature.

• The internal temperature can vary depending on the location of the bottles, at the top, mid-

dle or bottom.

• Adjustment may be necessary depending on the ambient temperature.

• Feel free to leave a thermometer inside the winecooler for regular monitoring.

• This winecooler is designed to hold a maximum of 15 standard size wine bottles (75cl) with-

out shelves and 12 standard size wine bottles (75cl) with shelves.

• Temperature setting:

• The keys and allow you to increase or decrease the temperature in 1°C increments

(temperature range is 4 ~ 22°C)

• The button allows you to turn the interior lighting on and off.

• In RETRO WINECOOLER:

• Press the button 6 seconds to switch from on to off.

• When you press the keys and for at least 2 seconds, get the temperature reading

in Fahrenheit or Celsius.

• After you set the temperature, the screen will return to displaying the temperature in the

refrigerator, but it might return to the point you have set gradually.

Before putting your winecooler into operation:

• Remove all components from both internal and external packaging and verify that none

of the parts are missing.

• Before the rst use, it is recommended to wait at least eight hours before connecting the

winecooler so that the oil can return to the compressor. Check that the water reservoir is

in place before plugging in the unit.

• Clean the internal surfaces of the unit with a soft cloth and warm water.

• Place your unit on a oor strong enough to support the weight of the fully loaded unit, if

on carpet place a wooden board between them. The space in which the product is located

must be at least 1 m3 per 8 g of refrigerant.

• Make sure the unit is level by adjusting the front feet under the unit. Make sure that the

winecooler rests on its legs in a stable manner. Do not tilt the winecooler more than 45º

from vertical when moving it.

• Install the appliance away from direct sunlight, which can damage the unit's cladding, and

away from heat sources which can increase its power consumption.

• Do not use excessive force anywhere. The metal rails on the bottom can have sharp edges,

so always unpack and handle with care. Carefully place the product to avoid scratching

the oor.

• This unit is designed for indoor use only.

• Caution: Make sure the unit is kept away from any substance that can cause combustion.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Create Winecooler Retro M Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info