Bedienungsanleitung Creative Video Blaster Webcam GO (Seite 5 von 40) (Englisch)

100905

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

6DIHW\5HJXODWRU \,QIRUPDWLRQ

7KHIROORZLQJVHFWLRQVFRQWDLQQRWLFHVIRUYDULRXVFRXQWULHV

CAUTION: This device is intended to be installed by the user in a

CSA/TUV/UL certified/listed IBM AT or compatible personal

computers in the manufacturer’s defined operator access area. Check

the equipment operating/installation manual and/or with the

equipment manufacturer to verify/confirm if your equipment is

suitable for user-installed application cards.

ATTENT IO N: Ce carte est destiné à être installé par l’utilisateur,

dans un ordinateur compatible certifié CSA/TUV/UL ou listé IBM

AT, à l’intérieur de la zone définie par le fabricant. Consulter le mode

d’emploi ou le fabricant de l’appareil pour vérifier ou confirmer si

l’utilisateur peut y installer lui-même des cartes périphériques.

1RWLFHIR U WKH86$

FCC Part 15: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, this notice is not a guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try one or more of the following

measures:

❑ Reorient or relocate the receiving antenna.

❑ Increase the distance between the equipment and receiver.

❑ Connect the equipment to an outlet on a circuit different from

that to which the receiver is connected.

❑ Consult the dealer or an experienced radio/TV technician.

CAUTION: To comply with the limits for the Class B digital device,

pursuant to Part 15 of the FCC Rules, this device must be installed in

computer equipment certified to comply with the Class B limits.

All cables used to connect the computer and peripherals must be

shielded and grounded. Operation with non-certified computers or

non-shielded cables may result in interference to radio or television

reception.

00RRGGLLIILLFFDDWWLLRRQQVV

Any changes or modifications not expressly approved by the grantee

of this device could void the user’s authority to operate the device.

1RWLFHIRU&D Q DGD

This apparatus complies with the Class “B” limits for radio

interference as specified in the Canadian Department of

Communications Radio Interference Regulations.

Cet appareil est conforme aux normes de CLASSE “B” d’interference

radio tel que spe’cifie’ par le Ministère Canadien des

Communications dans les règlements d’interfe’rence radio.

&RPSOLDQFH

This product conforms to the following Council Directive:

❑ Directive 89/336/EEC, 92/31/EEC (EMC)

/LPLWHG+DUGZDUH:DUUDQW\

Creative Labs warrants that the product enclosed herein to be free of

defects for a period of ninety (90) days from the date of purchase. In

the event of a defect in material or workmanship during the warranty

period, Creative Labs, at its discretion, will repair or replace the

defective product when the defective product is returned to Creative

Labs by the owner. The remedy for this breach of warranty is limited

to servicing or replacement only and shall not cover any other

damages, including but not limited to the loss of profit, special,

incidental, consequential, and other similar claims.

Creative Labs specifically disclaims all other warranties, expressed or

implied, including but not limited to implied warranties of

merchantability and fitness for a particular purpose with respect to the

defects of the products and program license granted herein. With

respect to the use of this product, in no event shall Creative Labs be

liable for any loss of profit or any commercial damage, including but

not limited to special, incidental, consequential, or other damages.

Some states/countries do not allow the exclusion of limitation of

liability for consequential, or incidental damages, in which case the

above limitation may not apply to you.

If the product is found to be defective, Creative Labs, at its option,

agrees to replace or repair the product at no charge except as stated

below, provided that you deliver the product with a return material

authorization (RMA) number and a dated proof of purchase. If you

ship the product to Creative Labs, you must assume the risk of damage

or loss in transit. You must use the original container (or the

equivalent) and pay the shipping charge.

Creative Labs may replace or repair the product with new or

reconditioned parts, and the replaced parts or product become the

property of Creative Labs. Creative Labs warrants the repaired or

replaced product to be free from defects in material and workmanship

for a period of ninety (90) days from the return shipping date.

Before returning any product, contact Creative Labs' Technical

Support (for telephone numbers and addresses, see the Technical

Support section of this document). If Creative Labs' Technical

Support verifies that the product is defective, the Return

Authorization Department will issue an RMA number to place on the

outer package of the product. Creative Labs cannot accept any

product that does not include an RMA number on the package.

'HFODUDWLRQRI&RQIRUPLW\

According to the FCC96 208 and ET95-19

Name: Creative Labs Inc.

Address: 1901 McCarthy Boulevard

Milpitas, CA. 95035

United States

Tel: (408) 428-6600

declares under its sole responsibility that the product

Trade Name: Creative Labs

Model Number: CT6860

has been tested according to the FCC / CISPR22/85

requirement for Class B devices and found compliant with

the following standards:

EMI/EMC: ANSI C63.4 1992, FCC Part 15 Subpart B

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received,

including interference that may cause undesirable

operation.

Ce matériel est conforme à la section 15 des régles FCC.

Son Fonctionnement est soumis aux deux conditions suivantes:

1. Le matériel ne peut étre source D’interférences et

2. Doit accepter toutes les interférences reques, Y compris

celles pouvant provoquer un fonctionnement indésirable.

Compliance Manager

Creative Labs, Inc.

12 August 1999

Creative Video Blaster Webcam GO Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info