Bedienungsanleitung Creda TVS3 (Seite 8 von 16) (Englisch)

498206

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

1. Select HIGH HEAT by pressing the

HEAT button.

2. Position the PROGRAMMES knob

on .

3. Press the START button..

1. Select HIGH HEAT by pressing

the HEAT button.

2. Position the PROGRAMMES knob

on .

3. Press the START button.

1. Select HIGH HEAT by pressing the

HEAT button.

2. Position the PROGRAMMES knob

on .

3. Press the START button.

Programme

What it does... How to set it...

Note:

Sensor

Drying

(average

loads)

Dries completely:

your clothes are ready to be

worn.

For average loads (from 1 to

3kg) of Cotton, polycotton or

synthetics.

! If you select LOW (Gentle)

HEAT, this programme will

not dry your clothes. For

Acrylic fibres or small loads

select Timed Drying.

This programme can also be

used for large loads if you

require a slightly drier result.

Automatic

Drying

(large

loads)

Dries completely:

your clothes are ready to be

worn.

For large loads (from 3 to 5kg) of

Cotton.

! If you select LOW (Gentle)

HEAT, this programme will

not dry your clothes. For

Acrylic fibres or small loads

select Timed Drying.

This programme can also be

used for average loads if you

prefer a damper result.

Timed Drying

up to 120 minutes

Dries wet clothes that will be

ironed, Acrylic fibres or small

loads (less than 1kg).

Consult suggested drying

times (see Laundry).

This programme can be used,

if you prefer to use a timed

drying programme for any

load.

Always allow the dryer to

complete this phase.

This is the programmes final phase.

Approximately 10 minutes before the

finish, the knob advances

automatically to the Cool Tumble

Phase. After the Buzzer will sound (if

selected) and the clothing is ready

to be taken out.

Heating elements turn

themselves off and clothing is

cooled down.

1. Select required heat setting HIGH

HEAT or LOW (Gentle) HEAT by

pressing the HEAT button.

2. Position the PROGRAMME knob

on the desired time.

3. Press the START button.

Speedy

Iron

Cool

Tumble

Phase

Brief programme (approximately

10 minutes) that softens fibres of

clothing that is ready for ironing.

! This is not a drying

programme (see below).

Speedy Iron

‘Speedy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which

fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle

relaxes the fibres and makes them easier to iron and fold.

! ‘Speedy Iron’ is not a drying programme and should not be used for wet articles of clothing.

For best results:

1. Do not load more than the maximum capacity.

These numbers refer to the dry weight:

Fabric Maximum load

Cotton and Cotton mixtures 2.5kg

Synthetics 2kg

Denim 2kg

2. Unload the dryer immediately after the end of the drying programme, hang, fold or iron the articles and put

them away in the closet. Should this not be possible repeat the programme.

The ‘Speedy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton

mix, and less well on acrylic fibres and on materials such as Tencel®.

Programmes

(Sensor Dryers: Model TVS3 only)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Creda TVS3 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info