Bedienungsanleitung Cressi Edy (Seite 28 von 50) (Englisch)

618069

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

217

By exceeding the depth of 4 ft. the FAEE mode will switch on the

counting, and the display will change as shown in picture 32,

delivering following information and updating it every second:

1 value of current depth, in meters (m) or feet (ft);

2 time of apnoea dive, given in minutes and seconds by the

icon "DIVE T";

3 maximum depth reached during the dive, given in meters

(m) or feet (ft) by the icon “MAX”;

4 indicator of segmented ascent rate

5 icon FAEE.

Other meaningful information may be obtained by keeping A

( ) depressed, as follows (picture 33):

1 value of maximum depth of apnoea dive, in meters (m) or

feet (ft);

2 water temperature, given in C° or °F degrees;

3 Icon of apnoea time alarm (if set);

4 Icon of maximum depth alarm (if set)

By keeping button C ( ) depressed, the display

shows the current time given in hours, minutes and seconds,

as shown in picture 34.

At any moment of your dive, should light conditions not allow you

an easy reading of the display, it is possible to switch on the

back-illumination, by depressing button B ( ). The display

back-illumination will last about 5 seconds and may be repeated

any time you want: the battery consumption is minimal.

The FAEE mode will remain set as long as the diver does not

change the setting.

NOTE: when is set on FAEE (apnoea) mode, you

may set DIVE mode (both air or nitrox); on the contrary, it

won’t be possible to set GAGE mode during the 48 hours

elapsing since last apnoea dive.

 DANGER: Cressi-sub strongly recommends to avoid

any apnoea diving after snorkel dives. Moreover, at least

two hours should elapse since the end of a snorkel dive

before starting an apnoea dive, which anyway should not

exceed the allowed maximum depth of 16 ft.

Related topics:

• 2.7.3. -

FAEE

(or Apnoea) mode parameters setting

• 2.7.1. - Maximum depth alarm

• 2.7.2. - Date and time adjustment

• 2.7.3. - Units of measurement setting.

• 3.7.1. - Surface interval after an apnoea dive (SURF) /

Apnoea dives memory and history (HIST)

• 3.7.2. - FAEE dive memory and history (HIST) reset

• 4.1.3. - Surface interval after a FAEE dive

• 4.2.3. - FAEE dive Logbook

• 4.3.3. - FAEE dive memory and history

3.7.1. - Surface interval after an apnoea dive

(SURF) / Apnoea dives memory and history

HIST

At a depth lower than 4 ft. and as long as computer

remains underwater (contact “E” on), its display will deliver

following information (picture 35-a):

1 Surface (or recovery) time, given in minutes (1 a) and

seconds (1 b);

2 Time of

last

apnoea dive, given in minutes and seconds

by the icon “DIVE T.”;

3 Maximum depth reached during

last

apnoea dive, given

in meters (m) or feet (ft) by the icon “MAX”.

4 TOTAL number of apnoea dives performed during the day;

5 Value of current depth, in meters (m) or feet (ft).

ENGLISH

EDY.qxd:EDY Manuale2006-2.qxd 20-06-2008 11:52 Pagina 217

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cressi Edy Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info