Bedienungsanleitung Crivit Sports 1-LD3875 - IAN 103142 (Seite 44 von 47) (Deutsch, Englisch, Holländisch, Französisch)

639390

Zoom out

Zoom in

Vorherige Seite

1/47

Nächste Seite

Total memory (14 days)

The order of the features is: Total Step/Total Distance (Total Step/Total Distance)

> Total Calories/Total Fat Burn (Total Calories/Total Fat Burn) > Odometer (G-

Dst/ODO) > BMI (BMI)

Note:

The stored daily values for calories, fat burn, average speed and maximum speed

are reset nightly at 0:00 but are stored in the 14-day memory.

BMI (Body Mass Index)

The BMI is a statistical measurement that can be used to judge a persons weight.

For adults, a value between 18.5 and 25 is considered normal. Values below

18.5 are considered "underweight". Values above 25 are considered

"overweight". Values above 30 are considered "Obese".

The BMI is only a coarse guideline because it does not take a persons body type

and body composition into consideration.

The watch automatically calculates your BMI from the values entered during setup.

Troubleshooting

The distance measurements are very imprecise

The watch uses the step length measured during calibration to estimate the

traveled distance.

Recalibrate the step counter. Calibrate it for walking and for running and use extra

care during the calibration.

Running on uneven surfaces may also result in bad calibration.

The heart rate is not shown or is shown incorrectly

Make sure the chest belt is positioned correctly and fits well

Your skin should not be too dry or too cold.

The contact areas can be slightly moistened to improve function

Electromagnetic interference may have an adverse effect on reception

The distance between watch and chest belt must be under 60cm

Other heart rate measuring devices within a 2m range may also cause

interference.

Wireless bicycle computers may cause interference

The batteries may be low and require replacing

The display is unreadable / the light does not work

Replace the batteries

Reset

Press SET and SEL simultaneously to totally reset the watch. All stored data will be

lost. This is the only way to change language and the units of measurement. Set up

the watch as described in the chapter “Setting up the heart rate monitor watch”.

Replacing the watch battery

The battery replacement can be performed by a watch maker in addition to a

water resistance test. To replace the battery yourself, please read the following

instructions first:

Remove the screws (1, 2, 3 and 4) from the back side of the watch with a small

Phillips screwdriver. Remove the caseback and the battery sticker. Use a small, flat

tool to open the latch (5) of the battery holder. Remove the battery and insert a

fresh 3V CR2032 battery with the (+) terminal facing upwards. Ensure that the

gasket (6) is seated correctly. Close the latch of the battery holder. Replace the

battery sticker and the caseback and replace the screws.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Crivit Sports 1-LD3875 - IAN 103142 Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info