21
1.1.2. Wheel Assembly on Models 535 and 737
The transporters are fitted with 20” spoked wheels and tyres dimension
47-406 (20” x 1.75”)
Assembly:
Press on the rubber cap and insert the
clevis axle into the hollow axle until it
engages. Repeat this on the other side
and check the wheels are securely
positioned.
1.1.3. Fitting the Handlebar
Both ends of the handlebar are pushed into the tubes at the upper rear section of the
transporter framework.
Tip: If the handlebar sticks, try using soap or silicon spray!
Check that the insert tube holes are properly aligned with the uptake tubes
and lock them on each side with the spring clip bolt, which you push
through from outside inwards and then secure with the spring clip loop.
Tip: Fitting the spring clip bolt is
made easier if you release the
folding catches and slightly fold the
trailer.
Safety note!
In the event of the vehicle tipping
over: Your handlebar grip acts as a
safety bar. So keep it permanently
installed, even when using the
transporter behind a bicycle!
The handlebar can be adjusted for two
positions. The lower position is
however only intended for small people
or children.
