Bedienungsanleitung Ctek LITHIUM XS (Seite 4 von 6) (Englisch)

648483

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

6 • EN

SAFETY

• The charger is designed for charging 12V Lithium-ion batteries with LiFePO

technol-

ogy

. Do not use the charger for any other purpose.

• Never try to charge non rechargeable batteries.

• Check the charger cables prior to use. Ensure that no cracks have occurred in the

cables or in the bend protection. A charger with damaged cables must not be used.

A damage cable must be replaced by a CTEK representative.

• Never charge a damaged battery.

• Never charge a battery with temperature below 0°C if not speciﬁed by the

battery manufacturer.

• Never place the charger on top of the battery when charging.

• Always provide for proper ventilation during charging.

• Avoid covering the charger.

• All batteries fail sooner or later. A battery that fails during charging is normally taken

care of by the chargers advanced control, but some rare errors in the battery could

still exist. Don’t leave any battery during charging unattended for a longer period of

time.

• Ensure that the cabling does not jam or comes into contact with hot surfaces or sharp

edges.

• Always check that the charger has switched to STEP 7 before leaving the charger

unattended and connected for long periods. If the charger has not switched to STEP 7

within 24 hours, this is an indication of an error. Manually disconnect the charger.

• This appliance is not designed for use by young children or people who cannot read

or understand the manual unless they are under the supervision of a responsible

person to ensure that they can use the battery charger safely. Store and use the bat-

tery charger out of the reach of children, and ensure that children cannot play with the

charger.

• Connection to the mains supply must be in accordance with the national regulations

for electrical installations.

TECHNICAL SPECIFICATIONS

Model number

1081

Rated Voltage AC

220–240VAC, 50–60Hz

Charging voltage

13.8/14.4 VDC

Charging current

5A max

Current, mains

0.65A

rms

(at full charging current)

Back current drain*

<1Ah/month

Ripple**

<4%

A mb i en t ***

temperature

-20°C to +50°C, output power is reduced

automatically at high temperatures

Charger type

8 step, fully automatic charging cycle

Battery types

12V LiFePO

batteries

Battery capacity

5–60Ah up to 120Ah for maintenance

Dimensions

168 x 65 x 40mm (L x W x H)

Insulation class

IP65

Weight

0.6kg

*) Back current drain is the current that drains the battery if the charger is not connected to

the mains. CTEK chargers have a very low back current.

**) The quality of the charging voltage and charging current is very important. A high cur-

rent ripple heats up the battery which has an aging eﬀect on the positive electrode. High

voltage ripple could harm other equipment that is connected to the battery. CTEK battery

chargers produce very clean voltage and current with low ripple.

***) The battery charger is designed to operate from -20°C to +50°C. However battery

manufacturers may recommend other temperature ranges for charging their batteries.

Please check battery speciﬁcations.

20018043B

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ctek LITHIUM XS Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ctek LITHIUM XS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info