Bedienungsanleitung Cube Cargo Hybrid 2022 (Seite 79 von 105) (Deutsch, Englisch)

779509

Zoom out

Zoom in

Vorherige Seite

1/105

Nächste Seite

| 25

CARGO HYBRID CARGO HYBRID

ÎBefore each journey, check that your

Cargo Hybrid is safe to drive.

Contact your bicycle dealer immediately

if you notice that the actual condition

of the Cargo Hybrid deviates from the

target condition.

Only use your Cargo Hybrid again when

it has been properly repaired by your

bicycle dealer.

Perform a visual inspection of the entire

Cargo Hybrid.

In the process, check the following:

•

all fixing screws for a correct screw

connection.

•

the entire Cargo Hybrid for notches, chip-

ping, deep scratches and other mechanical

damage.

•

whether loose parts have become caught

somewhere on the Cargo Hybrid, e.g.

branches, fabric remnants.

• whether the reflective strips on the tyres

are clean and clearly visible. Tyres without

reflective strips must be fitted with clearly

visible, clean reflectors.

If necessary, remove loose parts (e.g. branches)

and check whether, for example, your wheels

have been damaged by the loose parts.

Fix screw connections that have loosened, if

these are screw connections that you are

allowed to tighten yourself (see chapter

3.5.1„Which screw connections may you tighten

yourself?“).

If necessary, clean the reflective strips on the

tyres or clean and attach spoke reflectors.

If the reflective strips are no longer visible or

it is not possible for you to securely reattach

the spoke reflectors, consult your bicycle

dealer immediately.

Always make sure that the reflective

strips on the tyre or alternatively spoke

reflectors in accordance with StVZO on

your Cargo Hybrid are present, securely

fastened and not covered or dirty.

Contact your specialist bicycle dealer if the

visual inspection reveals defects of any kind

which you cannot remedy as described here.

6.2 Checking the wheels

Front and rear wheels are also called

wheels.

Your Cargo Hybrid has two wheels: one front and

one rear wheel.

Each wheel consists of the following:

• Hub

• Brake disc

• Spokes

• Rim

• Rim strip

• and tyres.

If your Cargo Hybrid is equipped with a derailleur

system, the sprocket or sprocket set is also

located on the rear wheel hub.

6.2.1 Checking the installation

Vigorously shake both wheels at right angles

to the direction of travel:

The wheels must not move in the clamping.

No cracking or crunching noises must be

audible.

The axle nuts must be tightly screwed and

the screw axle must be tightened with the

printed torque (see chapter 3.5.2„Torques

and screw connections“).

Contact your bicycle dealer if the inspection

reveals defects.

6.2.2 Checking the rims

1. Check the rims for wear.

Contact your bicycle dealer to find out how

to check the wear on rims without a wear

indicator.

2. Check the rims for wobbling:

To do so, lift up your Cargo Hybrid and

turn the front and rear wheels respectively.

Pay attention to the distance between the

frame strut or fork sheath.

The maximum permissible deviation per

revolution is 2 mm.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cube Cargo Hybrid 2022 Seite 79

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info