111230
12
Zoom out
Zoom in
Vorherige Seite
1/39
Nächste Seite
2. Fill the water reservoir
Fill the reservoir with cold water depending on the desired
number of cups (see height markings inside the reservoir).
Note: the coffee pot height markings represent the number
of cups obtained. The difference between this scale
and the water reservoir marks results from the
amount of water lost in wetting the grounds.
3. Add the ground coffee
Open the lid. Insert a #4 paper filter or the permanent
filter (never both of them at the same time) in the filter
holder. Add the desired amount of ground coffee in the
filter. Use one measuring scoop per cup. This average dose
can be adjusted to suit your taste.
4. Flip the lid close. Push firmly on top.
5. Make sure the coffee pot is in its position on the heating plate
before switching the coffeemaker on.
6. Turn the coffeemaker on.
B. OPERATING THE APPLIANCE
THE CONTROL PANEL
1. Clock: displays the time of the day and the “AUTO 1” and
AUTO 0 functions times.
2. Function knob: to set the time and program the automatic
on or off time.
2a. PROG: to set the desired “auto on” time (“AUTO 1
function).
2b. AUTO 1: auto-on feature to program the starting
time of the brew cycle. With green
indicator light.
2c. AUTO 0: auto-off feature from 0 to 4 hours after
coffeemaking start.
2d. : to set the time of the day.
2e. : to start the brew cycle directly.
3. O/I switch: works in tandem with the function knob to start
or stop a function.
4. Central red indicator light: works with the O/I switch
5. Heater plate control knob: to keep coffee warm after
brewing. 3 positions: L = low, M = medium and H = high.
6. Hour (“HRES”) and minute (“MIN”) buttons: to set the time
and automatic on and off times.
7. “CALC.” : descaling button: to eliminate calcium build-up.
With red descaling indicator light.
8. 1-4 cup setting: ensures optimum temperature whilst
preparing smaller pots of coffee (1 to 4 cups). With
orange indicator light.
PROGRAMMING
1. To turn the coffeemaker on and off
a. Turn on
• Turn the function knob on position.
• Flip the O/I switch up (I) and release.
The central red indicator light illuminates and the
brewing cycle starts.
• The end of brewing cycle is signalled by 5 beep sounds.
1
2a
2b
2c
2d
2e
3
4
5
6
78
12
DCC1200WE-DCC1200E IB 30/11/04 9:49 Page 13
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Cuisinart DCC 1200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Cuisinart DCC 1200

Cuisinart DCC 1200 Bedienungsanleitung - Englisch - 12 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info