Bedienungsanleitung Cupra Ateca 2020 (Seite 255 von 352) (Englisch)

817296

255

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

Help with parking and manoeuvring

●Do not hold the steering wheel during

manoeuvres to park or exit a parking space

until the system requests it. Doing so disa-

bles the system during the manoeuvre, re-

sulting in the parking being cancelled.

CAUTION

●In certain circumstances, the ultrasonic

sensors do not detect objects such as trail-

er tongues, bars, fences, posts or thin trees,

or an open (or opening) rear lid, which

could damage the vehicle.

●Retrofitting of certain accessories to the

vehicle, such as a bicycle rack, may inter-

fere with the operation of the Park Assist

system and cause damage.

●The Park Assist system uses as a refer-

ence parked vehicles, curbs and other ob-

jects. Make sure that the tyres and wheels

are not damaged while parking. If necessa-

ry, opportunely interrupt the parking ma-

noeuvre to avoid damaging the vehicle.

●The ultrasound sensors on the bumper

may be damaged or shifted in the event of a

collision, for example, when entering or ex-

iting a parking space.

●If you use high-pressure or vapour equip-

ment to clean the ultrasound sensors, do

not apply it directly unless very briefly and

always from a distance of more than 10 cm.

●A registration plate or plate holder on the

front with larger than the space for the reg-

istration plate, or a registration plate that is

curved or warped can cause:

–False detections.

–The sensors to lose visibility.

–Cancellation of the parking manoeuvre

or defective parking.

●If one of the ultrasonic sensors is dam-

aged, the area corresponding to that group

of sensors (front or rear) is deactivated and

cannot be activated until the fault is cor-

rected. However, you can still use the sen-

sors of the other bumper as per usual. If

there is a fault in the system, consult a spe-

cialist workshop. To do so, CUPRA recom-

mends going to a specialised CUPRA dealer

or any SEAT dealership.

Note

●In order to guarantee good system opera-

tion, keep the ultrasound sensors of the

bumper clean, free of snow or ice, and do

not cover them with adhesives or other ob-

jects.

●Certain sources of noise, such as rough

asphalt or paving stones and the noise of

other vehicles can induce the Park Assist

system or ParkPilot to give erroneous warn-

ings. The presence of metal objects can al-

so affect the manoeuvre.

●To become familiar with the system and

its functions, CUPRA recommends that you

practice operating the Park Assist system in

an area where there is not too much traffic

or in a car park.

Description of the parking assist sys-

tem

Fig. 177 In the upper part of the centre console:

button to switch on the Park Assist system.

The components of the Park Assist system

are the ultrasonic sensors located in the

front and rear bumpers, the 

››› Fig. 177 to

switch the system on and off and the mes-

sages on the instrument cluster display.

Prerequisites for parking

●The traction control system (ASR) must be

turned on

››› page 250 .

●Speed when passing next to the parking

space (parallel parking): do not exceed ap-

prox. 40 km/h (25 mph).»

253

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Cupra Ateca 2020 Seite 255

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Cupra Ateca 2020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info